AM General

ON CERTAIN VEHICLES, THE FUEL LINES CAN CONTACT A ROUGH EDGE ON THE TRANSMISSION CASE, RESULTING IN CHAFFED LINES AND FUEL LEAKAGE.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE TURN SIGNAL SWITCH PLASTIC CANCELLATION PIN CAN WEAR PREMATURELY CAUSING THE SIGNALS TO FAIL TO CANCEL AFTER COMPLETING A TURN.

VEHICLE DESCRIPTION: A POTENTIAL CHAFING CONDITION OCCURS BETWEEN THE FLEXIBLE BRAKE LINES WHICH CONNECT THE MASTER CYLINDER TO THE ABS MODULATOR. THIS CONDITION CAN LEAD TO ONE OR BOTH OF THE BRAKE LINES DEVELOPING A BRAKE FLUID LEAK.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE NUTS USED TO ATTACH THE MASTER CYLINDER TO THE HYDROBOOST BOLTS WERE OF THE METRIC TYPE RATHER THAN THE REQUIRED ENGLISH TYPE.

VEHICLE DESCRIPTION: BUSES EQUIPPED WITH ISRINGHAUSEN SEATS IN THE DRIVER POSITION. TWO WELDS LOCATED ON THE BACK REST ADJUSTMENT SIDE OF THE SEAT FRAME DID NOT MEET THE MANUFACTURER'S SPECIFICATIONS.

THE COATING USED TO PROTECT THE ACCELERATOR PEDAL SHAFT IS INCOMPATIBLE WITH THE BRONZE BUSHING THROUGH WHICH THE SHAFT PASSES. OVER TIME, AND IN THE PRESENCE OF A CORROSIVE ENVIRONMENT (WATER, ROAD SALT), THE SHAFT CAN CORRODE INSIDE THE BUSHING INCREASING THE AMOUNT OF FRICTION BETWEEN THE ROTATING SHAFT AND THE STATIONARY BUSHING.

UNDER HIGH AMBIENT TEMPERATURES (GREATER THAN 95 DEGREES FAHRENHEIT) AND THE FUEL TANK LEVEL BETWEEN 1/4 AND 1/2 FULL, THE FUEL TANK INTERNAL PRESSURE CAN INCREASE CAUSING THE TANK TO EXPAND. TANK EXPANSION CAUSES AN INTERFERENCE BETWEEN THE FUEL TANK PROTECTIVE SHIELD AND THE PROPELLER SHAFT RESULTING A HOLE IN THE FUEL TANK AT THE POINT OF SHIELD-TO-SHAFT CONTACT.

WATER CAN ACCUMULATE IN THE CRUISE CONTROL CABLE AND IF THE OUTSIDE TEMPERATURE IS BELOW FREEZING AND THE CRUISE CONTROL IS ENGAGED, THE WATER CAN FREEZE CAUSING THE CABLE TO BIND AND NOT RELEASE AS INTENDED WHEN THE BRAKE PEDAL IS APPLIED OR THE SYSTEM IS TURNED OFF AT THE MASTER CRUISE CONTROL SWITCH.