Recalls
ON CERTAIN TRANSIT BUSES EQUIPPED WITH DETROIT DIESEL SERIES 40 ENGINES, THE TURBOCHARGER CAN FAIL ALLOWING LUBRICATING OIL TO SPILL ONTO THE ENGINE.
ON CERTAIN TRANSIT BUSES MANUFACTURED WITH DETROIT DIESEL SERIES 50 ENGINE, THE TURBOCHARGER COMPRESSOR WHEEL CAN BREAK, RESULTING IN SHAFT IMBALANCE AND LUBRICATING OIL PASSES INTO THE EXHAUST SYSTEM.
ON CERTAIN BUSES EQUIPPED WITH CUMMINS ELECTRONIC CONTROL MODULES ON THE C8.3G AND L10G ENGINES, THE ECM DOES NOT HAVE THE ABILITY TO DETECT A THROTTLE FAIL-SAFE ENGINE SHUTDOWN COMMAND. THIS COULD RESULT IN AN UNANTICIPATED, UNCOMMANDED OPEN THROTTLE CONDITION WITHOUT WARNING.
ON CERTAIN TRANSIT BUSES EQUIPPED WITH ADHESIVELY BONDED ALUMINUM BUS DOOR PANELS, DUE TO AN IMPERFECT BONDING OF THE DOOR PANEL SKIN TO THE PANEL FRAME, ENVIRONMENTAL MOISTURE MAY INFILTRATE REGIONS OF IMPERFECT BONDING AND CAUSE SEPARATION OF THE FRAME AND DOOR PANEL.
ON CERTAIN TRANSIT BUSES EQUIPPED WITH VANNER 60 SERIES BATTERY EQUALIZERS, THE EQUALIZER COULD FAIL TO OPERATE PROPERLY AND CAUSE MALFUNCTION OF THE BATTERY CHARGING SYSTEM.
VEHICLE DESCRIPTION: TRANSIT BUSES EQUIPPED WITH VANNER 60 SERIES BATTERY EQUALIZERS. THE EQUALIZER COULD FAIL TO OPERATE PROPERLY AND CAUSE MALFUNCTION OF THE BATTERY CHARGING SYSTEM.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Gillig told its dealers about the 1998 Gillig Phantom: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 604897 | INFORMATION ON INSTALLING EXHAUST FLEX PIPE. *TT |
| 10115971 | Gillig has received reports of partial cracking in the steering gear mounting plate in some Low Floor buses. We are now requesting that owners of all Low Floor buses from model year 1997 through June, 2015 inspect the steering gear mounting plates per the instructions in this bulletin. Inspections should commence at the next Preventative Maintenance Cycle and continue at every 12,000 mile PM inspection thereafter. Steering Gear Mounting Plates found to have cracks less than 6 inches in length should be changed out at the earliest opportunity. Any bus found to have a Steering Gear Mounting Plat |
| 10044128 | GILLIG: GILLIG'S RECOMMENDATIONS FOR THE UNDERBODY MAINTENANCE CAN BE FOUND IN CHAPTER 11 OF YOUR SERVICE MANUAL. *JS |
| 10005855 | REAR SUSPENSION H-FRAME CRACK MODIFICATION. NOTIFICATION LETTER TO GILLIG PHATOM BUS OWNER, GILLIG INSTALLATION INSTRUCTIONS. 2002 MODELS ALSO INCLUDED. *TT |
NHTSA manufacturer communications (public domain)
NHTSA investigations
STRUCTURAL FAILURE OF REAR SUSPENSION
NHTSA Office of Defects Investigation