Problems owners report
Complaints filed with NHTSA about the 1993 Hyundai Excel, by the system named in each complaint. One complaint can name several.
- Power train8
- Engine and engine cooling4
- Electrical system3
- Seat belts3
- Equipment3
- Suspension1
- Visibility1
- Vehicle speed control1
- Exterior lighting1
- Wheels1
NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 2 injuries and 0 deaths reported
Compared with other years
NHTSA ODI complaints by model year
In New Zealand
6 1993 cars are on the New Zealand register; 17% arrived as used imports, 83% were sold new in New Zealand.
NZ Transport Agency Waka Kotahi, Motor Vehicle Register (March 2026) · CC BY 4.0
Recalls in Canada
1 Transport Canada recall for the 1993 Hyundai Excel.
| 1993176 30 Dec 1993 | Fuel System THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 301 - FUEL SYSTEM INTEGRITY. IN A DRIVER'S SIDE IMPACT THE REAR LEFT-HAND SPRING SEAT COULD PUNCTURE THE FUEL TANK… |
Transport Canada Vehicle Recalls Database · Contains information licensed under the Open Government Licence – Canada
Recalls
THE VEHICLES FAILED THE LATERAL MOVING BARRIER IMPACT TEST REQUIREMENTS OF FMVSS 301, "FUEL SYSTEM INTEGRITY." THE FUEL LEAKAGE FROM THE GAS TANK EXCEEDED THE MAXIMUM ALLOWABLE AMOUNT OF SPILLAGE.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Hyundai told its dealers about the 1993 Hyundai Excel: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 51905 | SHIFT CONDITION CAUSED BY SHORT CIRCUIT IN INHIBITOR SWITCH. *TW |
| 10230904 | This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation. |
| 10189989 | This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below. |
| 10183963 | This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area. |
| 10183960 | This bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin. |
| 10174808 | This bulletin provides information on identifying dealer stock vehicles with either: A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days. |
| 10169370 | The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to en |
NHTSA manufacturer communications (public domain)
NHTSA investigations
SCISSOR JACK FAILURE
NHTSA Office of Defects Investigation