11,145,731 US VINs16,875,657 Dutch plates3,603,918 businesses in 233 countries
English
AfrikaansAzərbaycancaBahasa IndonesiaBahasa MelayuCatalàČeštinaDanskDeutschEestiEnglishEspañolFilipinoFrançaisGaeilgeHrvatskiÍslenskaItalianoKiswahiliLatviešuLietuviųMagyarMaltiNederlandsNorskOʻzbekchaPolskiPortuguês (Brasil)Português (Portugal)RomânăShqipSlovenčinaSlovenščinaSrpskiSuomiSvenskaTiếng ViệtTürkçeΕλληνικάБеларускаяБългарскиКыргызчаҚазақшаМакедонскиМонголРусскийУкраїнськаქართულიՀայերենעבריתاردوالعربيةفارسیनेपालीहिन्दीবাংলাதமிழ்සිංහලไทยລາວမြန်မာខ្មែរ한국어日本語简体中文繁體中文
Check a VIN

2008 Infiniti EX35

44 owner complaints — the most of any EX35 model years, 5.5× the typical year. 3 recalls, 25 service bulletins.

44complaints · 5 crashes, 2 fires
3recalls
25manufacturer bulletins
75,300 mimedian mileage at failure

Problems owners report

Complaints filed with NHTSA about the 2008 Infiniti EX35, by the system named in each complaint. One complaint can name several.

  • Air bags11
  • Steering11
  • Engine8
  • Electrical system6
  • Vehicle speed control2
  • Power train2
  • Suspension2
  • Structure2
  • Fuel/propulsion system2
  • Seats2

NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 3 injuries and 0 deaths reported

Compared with other years

’07’08’09’11’1344’07’08’10’1344

NHTSA ODI complaints by model year

Fatal crashes in the US

From 2020 to 2023, 13 2008 EX35 vehicles were involved in crashes on US public roads in which someone died; 6 people died inside them, and 3 of the vehicles rolled over. This is a count, not a crash rate: it grows with the number of cars on the road.

NHTSA Fatality Analysis Reporting System (FARS), crash years 2020–2023 (public domain)

New York safety inspections

At its first New York inspection the 2008 Infiniti EX35 failed the safety check 2.13% of the time — 14% less often than the average 2008 passenger car (2.48%). Median odometer at inspection: 125,413 miles.

2,108first inspections
2.13%failed on safety
125,413 mimedian odometer
0.0%0.9%1.8%’08’10’122.1%0.0%0.9%1.8%’08’11’122.1%

NY DMV Vehicle Inspections (vezn-fmmk), initial inspections since Aug 2021 · how we count

Fuel consumption

Official Canadian test results for 1 variant: combined 12.5 L/100 km (about 19 mpg US), CO₂ 288 g/km.

VariantEngineTransmissionCityHighwayCombinedCO₂ g/km
EX35 AWD · Sport utility vehicle · Premium gasoline3.5 L, 6 cyl.AS514.510.112.5288

Litres per 100 km. Natural Resources Canada, Fuel consumption ratings (open.canada.ca) · Open Government Licence – Canada

Recalls in Canada

4 Transport Canada recalls for the 2008 Infiniti EX35.

2015060
11 Feb 2015
Steering
On certain vehicles, the steering column upper bearing retainer may fail due to a manufacturing defect. if this occurs, the upper bearing may experience additio…
2010383
3 Nov 2010
Lights And Instruments
On certain vehicles, the filament in the bulb of the Daytime Running Lamps (DRL) may burn out due to a shorter lifespan than expected. A loss of DRL illuminati…
2008363
6 Oct 2008
Other
On certain vehicles, a varistor in the Occupant Classification System (OCS) control unit located in the passenger seat cushion may have been manufactured incorr…
2008050
13 Feb 2008
Airbag
If the vehicle battery becomes significantly discharged and the voltage in the electrical system drops (because, for example, the ignition is left in the "ON" p…

Transport Canada Vehicle Recalls Database · Contains information licensed under the Open Government Licence – Canada

Recalls

15V054000 · Steering2 Feb 2015 · 16,973 vehicles

Nissan North America, Inc. (Nissan) is recalling certain model year 2008 Infiniti EX35 vehicles equipped with the power tilt/telescope option included in the premium package, manufactured June 29, 2007, to April 25, 2008, 2009 Infiniti FX35 and FX45 vehicles manufactured October 31, 2007, to April 16, 2008, and 2009 Nissan GT-R vehicles manufactured March 14, 2007, to April 25, 2008. The steering column outer tube may not be round, resulting in extra stress being applied to the upper steering bearing. This stress may cause the bearing retainer to fracture, creating extra play in the steering wheel or a possible loss of steering.

08V521000 · Electrical system7 Oct 2008 · 204,361 vehicles

NISSAN IS RECALLING 204,361 MY 2007-2008 ALTIMA, ALTIMA HYBRID, 350Z, 350Z ROADSTER, MY 2008 ALTIMA COUPE, ROGUE, MY 2009 MURANO, AND INFINITI MY 2007-2008 G35 SEDAN, MY 2008 G37 COUPE AND EX35 PASSENGER VEHICLES EQUIPPED WITH CONTINENTAL AUTOMOTIVE SYSTEMS' OCCUPANT CLASSIFICATION SYSTEM (OCS) CONTROL UNITS. A VARISTOR IN THE OCS CONTROL UNIT LOCATED IN THE PASSENGER SEAT CUSHION MAY HAVE BEEN MANUFACTURED OUT OF SPECIFICATION. UNDER CERTAIN CONDITIONS, THIS COULD CAUSE AN INTERRUPTION OF SIGNAL BETWEEN THE OCS AND THE AIR BAG CONTROL UNIT (ACU).

08V066000 · Air bags12 Feb 2008 · 16,365 vehicles

NISSAN IS RECALLING 16,365 MY 2008 INFINITI EX35 AND MY 2009 NISSAN MURANO VEHICLES. DUE TO INCORRECT SOFTWARE PROGRAMMING, THE AIR BAG CONTROL UNIT (ACU) MAY CAUSE THE PASSENGER AIR BAG NOT TO OPERATE AS DESIGNED IF THE VEHICLE BATTERY BECOMES SIGNIFICANTLY DISCHARGED.

Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.

NHTSA recalls · summaries in NHTSA's own words

Service bulletins

What Infiniti told its dealers about the 2008 Infiniti EX35: known faults, fixes and updates.

BulletinSummary
11002539INTELLIGENT KEY NOT DETECTED / ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
11002537CAN COMMUNICATION NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
11001653CAN COMMUNICATION CODES DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
11001182WINDOW GLASS WARRANTY INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
11001179REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
11001177WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10233611ABS/VDC CAN DIAGNOSIS INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10232646REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10232645WHEEL BEARING COLLISION DAMAGE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10232644WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10208930CAN COMMUNICATION NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10207844CAN COMMUNICATION CODES DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
10192822SERVICE INFORMATION Replacement 5-speed rear wheel drive Automatic Transmission (A/T) assemblies and replacement control valves (valve bodies) now come with blank Transmission Control Modules (TCMs). Blank TCMs come without software and must be programmed (not reprogrammed) and then configured after they are installed. When ordering a replacement A/T or control valve, use the Infiniti electronic parts information systems to obtain the correct software program part number See this bulletin for further detail.
10192806IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location, ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O-ring seal. See this bulletin for further detail.
10192802SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Infiniti by request if certain criteria are met. This bulletinlists the criteria and provides an application form for such replacements. See this bulletin for further detail.
10192788SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
10192728SERVICE INFORMATION The purpose of this bulletin is to give Infiniti dealers guidelines to help determine if windshield breakage is covered under warranty or is the customer?s responsibility. Nissan North America (NNA) is not responsible for damage to glass that is a result of objects striking or scratching the glass. However, NNA is responsible for manufacturing issues such as distorted glass and cracks that are due to improper installation or damage to the glass during vehicle assembly. NNA typically does not find any type of cracks in the windshield due to stress after the dealership PDI.
10192693SERVICE INFORMATION Windshield "foreign material" that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool. * Most any foreign material on the surface of the Windshield can be cleaned off by using #0000 super fine steel wool. >The #0000 grade super fine steel wool can be found in most hardware stores. Please see this bulleitn for further details.
10192639SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for fur
10192616SERVICE INFORMATION The information in this bulletin is provided to help ensure correct diagnosis and repair of fluid leaks. All fluid leaks, when properly diagnosed, should be repaired (whether under warranty or customer pay) to ensure proper vehicle operation. However, certain normal operating conditions can be misdiagnosed as a leak requiring repair. Unnecessary repair or replacement of parts in connection with incorrectly diagnosed "leaks" can negatively impact customer satisfaction, be time consuming and costly, and if not performed correctly can lead to future repairs. See this b
10192598SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer are capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be fol
10192589SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail.
10192514SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Infiniti STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger
10192511SERVICE INFORMATION DTC B2190 (NATS ANTENNA AMP) can be stored for the following reasons: 1. Something other than an Intelligent Key is inserted into the Key-Slot. 2. An Intelligent Key issue. 3. A wiring issue between the Key-Slot and the BCM. 4. A Key-Slot issue. If DTC B2190 is stored due to 1 or 2 above, it will not erase, or go to "PAST", until a known good registered Intelligent Key is inserted into the Key-Slot. For DTC B2190 diagnosis; first perform the Service Manual DTC Confirmation Procedure. See this bulletin for further detail.
10192505SERVICE INFORMATION Two methods are used to update/upgrade Navigation Map Data: 1. The customer goes to www.infinitinavigation.com and is mailed update disc(s) or SD card and installs data, OR 2. The dealership is mailed update disc(s) and the customer must visit the dealership to have data installed. Use the matrix in this bulletin to determine which method is utilized for each Applied Vehicle. See this bulletin for further detail.

NHTSA manufacturer communications (public domain)

NHTSA investigations

PE14034 · Steering:columnopened 4 Nov 2014 · closed 27 Feb 2015

Steering column separation

NHTSA Office of Defects Investigation