Problems owners report
Complaints filed with NHTSA about the 2022 Lincoln Aviator Phev, by the system named in each complaint. One complaint can name several.
- Electrical system5
- Engine5
- Unknown or other3
- Fuel/propulsion system3
- Back over prevention2
- Service brakes2
- Forward collision avoidance2
- Visibility/wiper1
- Air bags1
- Vehicle speed control1
NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 1 injuries and 0 deaths reported
Compared with other years
NHTSA ODI complaints by model year
Recalls
Ford Motor Company (Ford) is recalling certain 2022 Lincoln Aviator vehicles equipped with the 3.0L plug-in hybrid powertrain. The inlet charge port harness bus bar may become unseated, leading to a loss of drive power.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Lincoln told its dealers about the 2022 Lincoln Aviator Phev: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 10252664 | Some 2020-2023 Explorer/Aviator 3.0L plug-in hybrid electric (PHEV) vehicles may exhibit an illuminated malfunction indicator lamp (MIL) and/or powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P084B stored in the powertrain control module (PCM). This may be due to the software thresholds in the PCM. To correct this condition, perform the Service Procedure below to reprogram the PCM to the latest software level via the Ford Diagnosis and Repair System (FDRS). This TSB is superceded by TSB 24-2082 |
| 10252608 | This article supersedes TSB 24-2069 to update the vehicles affected. Some 2020-2023 Aviator 3.0L plug-in hybrid electric (PHEV) vehicles may exhibit an illuminated malfunction indicator lamp (MIL) and/or powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P084B stored in the powertrain control module (PCM). This may be due to the software thresholds in the PCM. |
| 10250306 | Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost hybrid engine, 2020-2023 Explorer vehicles equipped with a 3.3L hybrid engine and 2020-2023 Aviator vehicles equipped with a 3.0L hybrid engine may exhibit a malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM) and auto start/stop disabled. This may be due to a loose wiring connection to the belt integrated starter generator (BISG). The Workshop Manual (WSM) has recently been updated to provide new direction for DTC P0A1E. Refer to the WSM, Section 303-06 Starting Sy |
| 10249420 | Some 2020-2022 Aviator and 2021-2022 Corsair hybrid vehicles built on or before 01-Apr-2022 may exhibit charging concerns with the Lincoln dual-voltage charging cord (TurboCord). This style of charging cord can be indentified by one of the 220V prongs positioned sideways. If the vehicle charges properly using a 110/120V non-ground fault interrupter (GFI) outlet with the original 220V adapter removed, replace the adapter (part number VLC5Z-10B706-B) alone. This replacement adapter is available from accessories.lincoln.com > keyword search Turbo Cord, or through the local Ford Authorized Distrib |
| 10236587 | 2020-2023 Explorer/Aviator/Police Interceptor Utility Hybrid vehicles may exhibit a charging system warning in the message center and/or illuminated battery lamp with DTC B11D9 present in the body control module (BCM). Refer to Workshop Manual (WSM), Section 414-01, Pinpoint Test C for diagnosis and repair. If the 125 amp fuse on the 14300 wire harness at the auxiliary battery is open, do not replace a complete wire harness to obtain this fuse. The 125 amp fuse (service part number JU5Z-14526-A) is now available separately for service. If the 125 amp fuse is ok, check C1168 connector / SBF08 c |
| 10226727 | Some 2020-2022 Aviator/Explorer Hybrid vehicles may experience a concern where the EV power flow does not display in the center display screen. This may be due to accessory protocol interface module (APIM) software. To correct the condition, run the APIM-SYNC Module (APIM) Standard Programming application using the latest software level of the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 14G371 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
| 10224777 | Some 2021-2022 Mustang Mach-E/Escape plug-in hybrid electric vehicle (PHEV), 2020-2022 Aviator PHEV, and 2022 Transit battery electric vehicle (BEV) vehicles may experience an illuminated powertrain malfunction (Wrench) indicator and/or malfunction indicator lamp (MIL) with secondary on board diagnostic control module (SOBDM) diagnostic trouble code (DTC) U3000:49. This may be due to an internal SOBDM concern. To correct the concern, replace the SOBDM following Workshop Manual, Section 414-03B Removal and Installation, Secondary On-board Diagnostic Control Module. For claiming use base part # |
| 10222524 | Certain 2020 - 2022 Model Year Aviator PHEV and Explorer PHEV Vehicles Reprogram Powertrain Control Module In all of the affected vehicles, if the vehicle is charging via the charging cable and the customer requests a remote start, disconnects the charging cable, and then drives the vehicle, the engine may not start when needed and the vehicle will be limited to high voltage battery power. DTC P1A0C will set and a Stop Safely Now message will be displayed when the high voltage battery becomes depleted. |
| 10212126 | Some 2020-2022 Aviator/Explorer Hybrid vehicles may experience a low battery warning message displayed in the message center with diagnostic trouble code B11D9 present in the body control module (BCM). Refer to Workshop Manual, Section 414-01, Pinpoint Test C for diagnosis and repair. If the 125 amp fuse on the 14300 wire harness at the auxiliary battery is open, it is not necessary to replace a complete wire harness to obtain this fuse. Service part number JU5Z-14526-A is now available separately for service. |
| 10210236 | Some 2020-2022 Aviator Hybrid vehicles may exhibit an illuminated MIL and a Stop Safely Now message with only DTC P1A0C stored in the PCM. This may be due to the software in the battery energy control module (BECM). The condition occurs when the vehicle is started when the charging cord is connected. To prevent the condition from occurring, disconnect the charger prior to starting the vehicle. If the charger is not disconnected before starting, the ignition will need to be cycled before driving. Inform customers that they can continue to drive the vehicle and engineering is currently working o |
NHTSA manufacturer communications (public domain)
NHTSA investigations
Pedestrian alert sounds
NHTSA Office of Defects Investigation