Problems owners report
Complaints filed with NHTSA about the 2008 Mazda Mazdaspeed3, by the system named in each complaint. One complaint can name several.
- Power train23
- Engine and engine cooling5
- Unknown or other2
- Electrical system2
- Suspension2
- Wheels2
- Structure1
- Engine1
- Fuel system, gasoline1
- Vehicle speed control1
NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 2 injuries and 0 deaths reported
Compared with other years
NHTSA ODI complaints by model year
Recalls in Canada
1 Transport Canada recall for the 2008 Mazda Mazdaspeed3.
| 2011229 15 Jun 2011 | Visual System On certain vehicles, the ground terminal of the windshield wiper motor may have been inadvertently bent during vehicle assembly. Over time, the electrical resi… |
Transport Canada Vehicle Recalls Database · Contains information licensed under the Open Government Licence – Canada
Recalls
11V329000 · Visibility15 Jun 2011 · 103,300 vehicles
MAZDA IS RECALLING CERTAIN MODEL YEAR 2008-2009 MAZDA3 AND MAZDASPEED3 VEHICLES MANUFACTURED FROM JANUARY 7, 2008, THROUGH NOVEMBER 28, 2008. THE GROUND TERMINAL OF THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN INADVERTENTLY BENT DURING ASSEMBLY. IF THIS CONDITION EXISTS THEN OVER TIME THE ELECTRICAL RESISTANCE OF THE MOTOR CIRCUIT MAY INCREASE UP TO A POINT THAT THE WINDSHIELD WIPERS WOULD NOT WORK.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Mazda told its dealers about the 2008 Mazda Mazdaspeed3: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 11006987 | In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mi |
| 10232299 | Speedometer replacement procedure |
| 10213430 | Excessive condensation or water within the headlamp assembly caustion |
| 10213427 | HandsFree bluetooth module and/or text messaging troubleshooting procedure |
| 10213330 | PreMixed long life "FL22" Engine Coolant |
| 10200527 | This service bulletin provides information regarding the proper use of the drivers floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage. |
| 10188016 | This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure. |
| 10188015 | The Mazda DCA-8000PM is required for all warranty battery testing. If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code. |
| 10186703 | In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer |
| 10186701 | A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This condition is usually worse during high humidity conditions. Mazda Air Cooling Coil Coating is available to encapsulate the mold to reduce odors. If the product is properly applied, it can effectively reduce the musty/mildew odor for up to three years. |
| 10186693 | Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. |
| 10179228 | New CARB regulation regarding mandatory checking and documenting of tire pressure whenever a vehicle is in for service work. This applies to all service shops (including Mazda dealerships) in California effective September 1, 2010. |
| 10177847 | When encountering a vehicle with paint damage, refer to the "Mazda Paint Warranty Guide" to determine cause, prevention, remedy, and warranty coverage (if applicable). |
| 10170661 | In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle |
| 10154879 | In support of the new MRT distribution, Mazda will ship to dealers a new Dual Purpose Diagnostic Leak Detector beginning March, 2019. Training videos will be posted to MGSS shortly and Workshop Manual procedures will be revised gradually. |
| 10129576 | Some vehicles may have a MIL illumination with DTC's P0441, P0442, P0455, or P0456 stored in memory. To determine the location of the evaporative system leak, follow the repair procedure below. P0441 - Evaporative emission control system incorrect purge flow P0442 - EVAP system leak detected (small leak) P0455 - EVAP system leak detected (gross leak) P0456 - EVAP system leak detected (very small leak) NOTE: P0441 is a DTC for purge flow, however, it can be stored when evaporative emissions are leaking from the fuel filler cap. Evaporative emissions leak from the fuel filler cap when the cap is |
| 10111036 | In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is 2017 Mazda North American Operations, U.S.A. allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, a Mazda dealer can get the odometer setting updated to reflect the correct mileage at the time of replacement for both warranty and customer pay repairs, therefore resulting in a higher level of customer satisfaction. Since odometer setting servic |
| 10098367 | IN ACCORDANCE WITH FEDERAL REGULATIONS, FOLLOW THE PROCEDURE LISTED BELOW WHEN REPLACING A SPEEDOMETER.NOTE:MAZDA VEHICLES ARE MANUFACTURED WITH TAMPER-PROOF SPEEDOMETERS.WHEN A SPEEDOMETER IS REPLACED, THE NEW SPEEDOMETER WILL READ ZERO (0) MILES.THIS PROCEDURE IS EXTREMELY IMPORTANT TO ACCURATELY REPRESENT ACTUAL VEHICLE MILEAGE.PRIOR TO SPEEDOMETER REMOVAL, COMPLETE THE INFORMATION REQUIRED ON THE SPEEDOMETER REPLACE-MENT LABEL. LABELS CAN ONLY BE ORDERED THROUGH MSTORE, NOT MDCS. |
| 10098003 | SOME CUSTOMERS MAY REPORT A SLIGHT CLUNK/BANG/BUZZ NOISE OR JOLT FROM THE FRONT OF THE VEHICLE. THIS CONCERN WILL MOST LIKELY OCCUR DURING THE VEHICLES FIRST FORWARD MOVEMENT AFTER STARTING THE ENGINE. THIS IS A NORMAL OPERATING NOISE OF THE ANTI-LOCK BRAKE SYSTEM (ABS). DO NOT ATTEMPT ANY REPAIRS. |
| 10097754 | THE MULTI INFORMATION DISPLAY (MID) AND NAVIGATION SYSTEM SUPPORT FOR DIAGNOSTICS, PARTS AUTHORIZATION, AND PARTS EXCHANGE REQUIRE CONTACTING THE PROPER SOURCE. PLEASE CONTACT THE APPROPRIATE SOURCE BY REFERRING TO THE FOLLOWING TABLES. |
| 10044209 | MAZDA: VARIABLE TIMING (VVT) NOISE AND/OR TIMING CHAIN NOISE. THE REPAIR PROCEDURE FLOWCHART, REPAIR PROCEDURE AND WARRANTY INFORMATION HAVE BEEN REVISED. ALSO INCLUDED MODEL MAZDASPEED3 MODEL YEAR 2010 *JS |
| 10043875 | MAZDA: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. DUE TO WEAR ON LOCK PIN HOLE IN VVT ROTOR OR BREAKAGE OF VVT CASE, LOUD TICKING NOISE (KNOCKING/RATTLE) IS HEARD, FROM TIMING COVER AND/OR VALVE (CYLINDER HEAD) COVER, WHEN ENGINE IS STARTED AFTER COLD CONDITION. *PE |
| 10043874 | MAZDA: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. DUE TO INSUFFICIENT CRANK CASE VENTILATION, HEAVY WHITE SMOKE APPEARS FROM EXHAUST PIPES, AFTER LONG IDLE PERIODS, RESULTING IN OIL LEAKAGE PAST EXHAUST TURGINE SHAFT SEAL. *PE UPDATED 5/14/12. *PE UPDATED 12/18/12. *PE |
| 10043662 | MAZDA: TPMS WARNING LIGHT ILLUMINDATED. THIS MAY BE CAUSED BY DAMAGE TO THE VALVE NUT AND/OR VALVE STEM OF THE WHEEL. *KB |
| 10041267 | MAZDA: FUEL PUMP OR PRESSURE LINE PIPE INSTALLATION/REMOVAL INFORMATION. *RM |
NHTSA manufacturer communications (public domain)