Problems owners report
Complaints filed with NHTSA about the 2000 Mercedes-Benz CLK320, by the system named in each complaint. One complaint can name several.
- Electrical system6
- Vehicle speed control3
- Air bags3
- Power train2
- Unknown or other2
- Tires1
- Structure1
- Steering1
NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 3 injuries and 0 deaths reported
Compared with other years
NHTSA ODI complaints by model year
Recalls
No recall campaigns cover the 2000 Mercedes-Benz CLK320.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Mercedes-Benz told its dealers about the 2000 Mercedes-Benz CLK320: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 612197 | BRIEF INFORMATION ON INSTALLING TELEPHONE. *TT |
| 11009122 | Complaint Washer fluid system leaks Cause Various possible causes: 1. Washer fluid reservoir itself. 2. Seal on washer fluid pump/washer fluid reservoir. 3. Washer fluid pump. 3.1. Distributor housing leaks. 3.2. Pump fitting leaks. 3.3. Washer fluid hose cannot be snapped into place on pump fitting. 3.4. Washer fluid hose will not stay on pump fitting, although connector OK. 4. Washer fluid line. 4.1 Connector will not stay on pump fitting because it is broken. 4.2 Sealing ring in connector missing. 4.3 Sealing ring in connector fitted, but deformed and therefore leaks. 4.4 Damage to washer l |
| 11008091 | Complaint During a phone call, the called party has difficulty understanding/cannot understand the driver, or interference/background noises are audible to the called party during a call. It becomes increasingly difficult to understand as the speed rises. Cause A. Seating of the microphones in the headliner. Side edges are covered by the textile cover (see picture "1") B. Assembly of microphones (B25/20 or B25/21) in the headliner. C. Dirt inside the microphone housing Remedy 1. Press finger on rear of microphone (on adhesive tape) 2. Remove microphone cap from the front 3. Eliminate protrudin |
| 11007974 | Complaint Headlamps leaking or fogged Cause The fogging of the headlamp is a natural phenomenon which can occur under certain climatic conditions. In contrast to a leaky headlamp, physical fogging does not result in a technical impairment of the headlamp. A leak test must be performed to determine if physical fogging exists or if the headlamp is leaky. Remedy In advance, observe LI82.10-P-078301 "Headlamps or Front Fog Lamps Leaking or Fogged". 1. Prepare headlamp/check for external damage: For headlamps with a closed system 1. Check the headlamps for any external damage and check also for cor |
| 11007753 | Complaint Headlamp or front fog lamp leaky or fogged Cause Fogging of the headlamps is a natural phenomenon, which can occur under certain climatic conditions. It does not lead to any technical impairment of the headlamp. Headlamps comply with all applicable standards. If a pressure compensation diaphragm is fitted in the housing cover, then the lamp unit is a "closed system". Remedy Headlamp: Remedy 1 Clearing fogged/condensed LED headlamps and LED rear lamps: 1. Drive vehicle into workshop (temperature higher than +18 C/+64.4 F) and connect the exhaust extraction. Note: Do not perform an eng |
| 11005294 | Complaint Rear lamps fogged up/not leaktight. Cause Fogging of the rear lamps is a natural phenomenon, which can occur under certain climatic conditions. This does not lead to any technical impairment of the rear lamps. Remedy Rear lamp: Remedy 1: Clearing fogged/condensed rear lamps: 1. Drive the vehicle into the workshop (temperature higher than +18 C/+64.4 F) Note: Do not wash the vehicle or subject it to high-pressure cleaning before the defogging test. 2. Switch off the engine and connect battery support via a charger. 3. Open the trunk. 4. Switch on the exterior lighting. 5. Leave the ve |
| 10248162 | Crease formation on genuine leather seat covers in vehicles with low mileage Objects left on the seats for extended periods of time (pressure marks). Objects wedged between the seat backrest and seat cushion (e.g. seat belt buckle). Light initial creases due to vehicle handling. Light creases in the outer covers originating from the production process (missing finish). Heat treatment of the seat covers using heat gun and plastic wedge. Be very careful to not overheat the seat material! |
| 10181124 | Harsh engagement when changing gear range from P to D or R |
| 10167553 | Combination message: "Clean fuel filter" is displayed. The fault code 162500 (water level message - Bosch) or P226997 (water level message - Delphi) or 171600 (filter load - Bosch) is stored in the engine control unit. |
| 10166976 | Message in instrument cluster "DISTRONIC PLUSCurrently Unavailable - See Owner's Manual" |
| 10166081 | Noise complaints when load on backrest frame changes. Affects the driver and front passenger seats. Also perform the remedial action if you are performing work on: - backrest frame - backrest cover or - guide rail of head restraint. If the backrest frame is exposed as a result, the actions must always be performed in order to avoid follow-up repairs. |
| 10151959 | Seat belt extender toothed rack sluggish or makes noises |
| 10136041 | Selector lever blocks in position "P" (brake applied) |
| 10136029 | SENTEX gate operator with Clik Card Remote not compatible with Homelink |
| 10135917 | Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation hose) |
| 10135628 | iPhone mobile phone: Various complaints after software update to iOS8 |
| 10044222 | MERCEDES BENZ: FRONT OR REAR SEAT BELT DOES NOT ROLL UP CORRECTLY. DIRT DEPOSITS ON THE SEAT BELT GUIDE DUE TO SOILED SEAT BELT. ALSO INCLUDED MODELS 169, F CELL, 246, AND 231. NO MODEL YEARS GIVEN. *JS |
| 10044181 | XENTRY: RATTLING/THUMPING NOISES FROM THE AREA OF THE STEERING ON ROUGH ROADS OR WHEN DRIVING OVER ROAD UNDULATIONS. NO MODEL YEARS GIVEN. ALSO INCLUDED MODELS 168 AND 172. *JS |
| 10033070 | XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. NO MODEL YEARS LISTED. *PE |
| 10028586 | MERCEDES VEHICLE: THE SRS INDICATOR LAMP IS ILLUMINATED AND CODE B1058 AND B2DBO ARE STORED, REPLACE THE SRS CONTROL UNIT. MODELS 203 AND MODEL 209. MODEL YEARS UNKNOWN. *PE |
| 10028585 | MERCEDES VEHICLES: THE XENON OR BI-XENON HEADLAMP NOT FUNCTIONING. A FUNCTION DESCRIPTION CAN BE FOUND IN WIS DOCUMENT GF8S.10-P-20010 (203), GF82.10-P-0003Q (209); GF82.10-P-3002R (230). MODEL YEARS UKNOWN. *PE |
| 10020460 | PLAY IN THE RACK AND PINION STEERING SYSTEM. MODELS 203, 209, 210, 211, 215, 220, 230. MERCEDES BENZ. *KB UPDATED 5/13/09. *PE |
| 10015377 | REVISED REPAIR PROCEDURE AND ADDITIONAL APPLICABLE MODELS. MODEL 170, 202, 208 AND 210 MODELS. FRONT FOG LAMP(S) INOPERATIVE. MERCEDES-BENZ. *TT MODEL YEARS: 1994-2004. UPDATED 09/09/08. *PE |
NHTSA manufacturer communications (public domain)
NHTSA investigations
PE03058 · Engine and engine cooling:engine:gasoline:belts and associated pulleysopened 17 Dec 2003 · closed 22 Apr 2004
ENGINE CRANKSHAFT PULLEY FAILURE
NHTSA Office of Defects Investigation