Mercury Mountaineer

FORD IS RECALLING CERTAIN MODEL YEAR 2010 FUSION, EXPLORER, EXPLORER SPORT TRAC, AND MERCURY MILAN AND MOUNTAINEER VEHICLES MANUFACTURED BETWEEN DECEMBER 15, 2009 THROUGH FEBRUARY 3, 2010 EQUIPPED WITH FRONT SEAT MANUAL RECLINERS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 202, "HEAD RESTRAINT." THE RECLINER GEAR PLATE TEETH MAY BE OUT OF DIMENSION SPECIFICATION WHICH COULD RESULT IN LIMITED PAWL TO GEAR PLATE TOOTH ENGAGEMENT.

FORD IS RECALLING MODEL YEARS 1995-2003 WINDSTAR, 2000-2003 EXCURSION DIESEL, 1993-1997 AND 1999-2003 F-250 SD THROUGH F-550 SD DIESEL, 1992-2003 E-150 THROUGH E-550, 1995-2002 EXPLORER, 1997 AND 2002 MERCURY MOUNTAINEER, 1995-1997 AND 2001-2003 RANGER, AND 1994 F53 VEHICLES EQUIPPED WITH THE TEXAS INSTRUMENTS SPEED CONTROL DEACTIVATION SWITCH (SCDS). THE SCDS MAY LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH THE 4.6L ENGINE AND 6R TRANSMISSION, THE BOLT SECURING THE TRANSMISSION OIL COOLER LINE FITTINGS AT THE TRANSMISSION MAY NOT HAVE BEEN SUFFICIENTLY TORQUED DURING VEHICLE ASSEMBLY. AS A RESULT, THE BOLT MAY LOOSEN AND THE TRANSMISSION OIL COOLER LINES MAY DISENGAGE FROM THE TRANSMISSION, CAUSING A TRANSMISSION FLUID LEAK.

ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

ON CERTAIN TRUCKS, PASSENGER CARS AND SPORT UTILITY VEHICLES, THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN PRODUCED WITHOUT GREASE BEING APPLIED TO THE OUTPUT SHAFT GEAR.

ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH HIGH BACK SEATS, THE UPPER BOLT ON THE DRIVER'S SIDE HIGH BACK SEAT, THAT ATTACHES THE SEAT RECLINER MECHANISM TO THE SEAT BACK FRAME, COULD FRACTURE. IF THE BOLT FRACTURES AND DOES NOT JAM IN THE SEAT BACK FRAME, THE SEAT BACK MAY RECLINE UNTIL IT MAKES CONTACT WITH AN OBJECT BEHIND THE SEAT, SUCH AS THE SECOND ROW SEAT CUSHION.

ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH SPEED CONTROL AND 4.0L SOHC ENGINES, IF THE STRAND COVER ON THE SPEED CONTROL CABLE BECOMES FLARED AT THE END, THE SPEED CONTROL CABLE MAY BIND WHEN THE SPEED CONTROL IS ACTIVATED.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE RIGHT SIDE TIRES MAY HAVE HORIZONTAL CUTS ON THE EDGE OF THE TREAD THAT COULD HAVE OCCURRED DURING VEHICLE ASSEMBLY.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES EQUIPPED WITH 4.0L SOHC ENGINES AND STILL RETAIN THE ORIGINAL THROTTLE BODY (PART NUMBERS 97JF-9E926AB OR 97JF-9E926-AC). SOME OF THE ORIGINAL THROTTLE BODIES INSTALLED ALLOWED A GAP BETWEEN THE PLATE AND BORE TO BE BUILT TOO NARROW. THIS REDUCED CLEARANCE ALLOWED THE ENGINE DEPOSITS NORMALLY PRESENT IN THE THROTTLE BODY TO CONTACT OR BRIDGE THE GAP. IF THE ENGINE DEPOSITS BRIDGED THE GAP BETWEEN THE THROTTLE PLATE AND BORE AND THEN HARDENED, ON THE INITIAL APPLICATION OF THE ACCELERATOR PEDAL AFTER THE ENGINE HAS COOLED, THE OPERATOR WOULD NEED TO APPLY ADDITIONAL FORCE TO THE ACCELERATOR PEDAL TO BREAK THE BRIDGE.

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. UNDER CERTAIN CONDITIONS, A FRONT SWAY BAR LINK CAN FRACTURE.

VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

VEHICLE DESCRIPTION: 4-DOOR SPORT UTILITY VEHICLES EQUIPPED WITH SIDE AIR BAGS. THE SUBJECT VEHICLES HAVE A REVISED LEVEL SIDE CRASH SENSOR THAT COULD DEPLOY THE SIDE AIR BAG IF THE IGNITION KEY IS IN THE "RUN" POSITION AND THE SEATBELT WEBBING IS FORCIBLY EXTRACTED FROM A LOCKED RETRACTOR WITH A JERKING MOTION.