Recalls
Van Hool N.V. (Van Hool) is recalling certain 2015-2018 Van Hool TD925 and TDX25 vehicles, equipped with certain Kidde Technologies, Inc. (KTI) KDS-25 fire extinguishers as part of the optional fire suppression system. The actuator of the extinguisher may not function properly, preventing the fire extinguisher from discharging the fire suppression agent in the event of a fire.
Van Hool N.V. (Van Hool) is recalling certain 2015-2018 CX45, TD925, TDX25, TX40, TX45, and 2016-2018 CX35 motorcoaches. The passenger seat belt buckles outer casing may fail leaving the seat belt buckles exposed.
Van Hool N.V. (Van Hool) is recalling certain 2010-2014 C2045 and T2145 motorcoaches, 2014-2015 TX40 motorcoaches, 2014-2017 TX45 motorcoaches, 2011-2015 TD925 motorcoaches, 2014-2016 CX45 motorcoaches and 2010-2013 T2140 motorcoaches. When the vehicle is started in low temperatures, the steering wheel may be difficult to turn.
Van Hool N.V. (Van Hool) is recalling certain model year 2010-2014 C2045 and T2145; 2010 C3045; 2016 CX35; 2014-2016 CX45 and TX45; 2009-2016 TD925; 2015-2016 TDX25 and TX40 and 2010-2013 T2140 motorcoaches. In the affected vehicles, the front steering knuckle carriers may crack.
Van Hool N.V. (Van Hool) is recalling certain model year 2012 A300L, 2011 C2045, 2011-2013 T2145, 2012-2015 TD925, 2016 TDX25, and 2014-2015 TX45 motor coaches equipped with certain Recaro Ergo-M Commercial Bus Driver Seats. The affected seats have J-Brackets that may be missing welds which could allow the seat belt anchorage assembly to separate from the J-Bracket.
Van Hool is recalling certain model year 2015-2016 TD925 vehicles manufactured May 13, 2015, to October 22, 2015, and 2015-2016 TDX25 vehicles manufactured December 23, 2014, to October 22, 2015. In the affected vehicles, the air brakes may take an excessive amount of time to release. As such, the vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 121, "Air Brake Systems."
Van Hool N.V. (Van Hool) is recalling certain model year 2014-2015 TD925 vehicles manufactured October 11, 2013, to December 12, 2014, and 2015 TDX925 vehicles manufactured on December 23, 2014. The affected vehicles are equipped with Cummins engines that may have their idle speed set too low.
Van Hool N.V. (Van Hool) is recalling certain model year 2014 C2045, 2014-2015 CX45, TD925, TX40, TX45, and 2015 TDX25 coaches. The affected vehicles have front steering knuckle carrier that may break.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Van Hool told its dealers about the 2015 Van Hool TD925: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 11010424 | This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administrations (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject. |
| 10248730 | This service bulletin provides you with information about the location of emergency side window decals so that the vehicle meets the National Highway Traffic Safety Administrations (NHTSA) Federal Motor Vehicle Safety Standards (FMVSS) in the U.S and the Canadian Motor Vehicle Safety Standards (CMVSS) in Canada about this subject. |
| 10245193 | Two different types of step nose lighting units have been installed during manufacturing. The early units (which are limited available as spare part) are provided with a LED card for the downward light and an optical fiber for the upward light. These units have a small circuit board with a resistor to reduce the 24V power supply to an operating voltage of 3V for the optical fiber (refer also to figure 1). The new units have an optical fiber for both the downward and upward light, and do not have a circuit board to reduce the voltage supply. These lighting units may not be connected directl |
| 10245018 | Van Hool regularly receives questions regarding the bolts securing the wheel suspension arms of the front axle and tag axles to the chassis. The purpose of this service information bulletin is to inform and is partly a reminder of what already is mentioned in the maintenance manual. |
| 10233467 | Service Information: In its production process, Bock, manufacturer of refrigerant compressors, has switched to a new type of motor protection switch for the electric motor of the refrigerant compressor. As the MP10 motor protection switch (VH11472802) is no longer made available as a spare part, as of now you will receive the new INT69G motor protection switch (VH11691810) when ordering. The MP10 and the INT69G are interchangeable, but fastening and electric connection are different. |
| 10219652 | Product Improvement: ALL VEHICLES WITH LIGHT-ALLOY WHEELS - Introduction of wheel-end monitoring system (WEM). Van Hool has released a wheel-end monitoring system (WEM) which can be installed on all vehicles equipped with light-alloy wheels. The WEM is installed at the outboard side of the wheel and monitors vibrations produced by the wheel bearing. It warns in case of bearing raceway spalling by flashing a red LED on the unit. The WEM is delivered with a magnet which is used to change from "transport" to "standstill" mode. |
| 10210015 | Service Information: Removal and installation of Shaw DEF tank sensor unit The purpose of this service information bulletin is to inform you about the removal and installation of a Shaw DEF tank sensor unit. |
| 10209998 | Product Improvement: Introduction of new generation DEF tank sensor unit Some previous manufactured DEF tank sensor units are no longer available as spare part. This service bulletin gives you information about the visual points of difference between the generations and which one to order in case of replacement. Most of the replacements are direct fit, except for the sensor units with an asterisk in the table which must be secured with a split mounting ring consisting of two halves instead of the original closed mounting ring. |
| 10209994 | Service Information - Introduction of new 4/2 solenoid valve in compressed-air circuit Van Hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous Knorr-Bremse (Bosch) solenoid valve (VH11102170) is no longer made available as spare part, customers will receive a Wabco solenoid valve (VH660526759) when ordering. Both valves are interchangeable, but some differences must be considered. Consult the information in this service bulletin for a proper installation. |
| 10209992 | Service Information - Maintenance operations related to refrigerant compressor oil This service information bulletin is a reminder/update about refrigerant compressor oil maintenance. To ensure a reliable system, it is important to perform the maintenance on a regular base as mentioned further on. |
| 10206916 | To change "Quick release valve" of front axle brakes. |
| 10206915 | DANA, manufacturer of axles, has informed Van Hool that the procedure for checking the wheel bearing end-play has been changed. |
| 10206914 | Introducion to electronic contrlolled air suspension(ELC). |
| 10206910 | To inspect auxiliary structure around front axle for not properly executed welds. |
| 10206909 | To Reinforce the TD925 Chassis in the drive axle area. |
| 10201570 | SERVICE INFORMATION BULLETIN: Van Hool has switched over into production to a new type of 4/2 solenoid valve in the compressed-air system. As the previous Knorr-Bremse (Bosch) solenoid valve (VH11102170) is no longer made available as spare part, you will receive a Wabco solenoid valve (VH660526759) when ordering. Both valves are interchangeable, but some differences must be considered. Consult the information in this service bulletin for a proper installation. |
| 10190134 | Service Information Bulletin: What to do in case of prolonged vehicle standstill. This service bulletin provides an overview of works to be performed during prolonged vehicle standstill. |
| 10182687 | Service information Bulletin: Stress-free installation of flex pipe This service bulletin gives step-by-step instructions on how to install the flex pipe properly. The flexible part of the flex pipe handles thermal expansion and engine vibration, and is prone to premature breakdown in case of incorrect installation. |
| 10179511 | Van Hool N.V. and ABC Companies did not release any new service bulletins during the month of August 2020. |
| 10174983 | Service Information: he purpose of this service bulletin is to inform you about the innocent traces of lubricant at the bottom of the transmission bell housing on new vehicles. They are caused by the protective anti-corrosion coating at the inside of the bell housing which becomes liquid at transmission operating temperature. This phenomenon is temporarily and no indication that there is a sealing problem! The lubricant can easily be removed with ordinary cleaning product. |
| 10174982 | Service Information: This bulletin is being released as a reminder of the importance of wheel bearing preventive maintenance. Check the wheel bearing end-play every 50,000 miles*, and when having any work done on the brakes or any other component on the axle end. |
| 10174980 | Field Change Program: It has been reported that the red 6 mm2 power supply wire connected at stud MP+24V in junction box Vanner is not protected by a fuse. This wire runs from stud MP+24V to terminal block DVB in junction box EKA, from there the wire continues to fuse holder ZB3 in junction box EKA to power fuses Z83.1 and Z86. Install an additional 30A in-line fuse in junction box Vanner to make sure that this wire is protected against overheating in case of overcurrent. |
| 10168582 | To isolate fuel tank from understructure. This work procedure explains how to isolate the fuel tank from the understructure to prevent fuel tank cracking due to structural loads during severe operating conditions. |
| 10168579 | Product Improvement. Introduction of new single check valves in cooling-circuits deaeration lines.Van Hool have recently switched over into production a new type of single check valve. Contrary to the previous type equipped with a plastic housing, the new type comprises an aluminium housing. Because of this, they are better suited to resist higher coolant temperatures. As the new type can also be used on previoulsy sold vehicles, only the new type will be available as a spare part. This service bulletin applies to All Van Hool Vehicles. |
| 10162036 | To remove/install wheel-nut caps. Some vehicles have plastic chrome-coloured wheel-nut caps on top of the wheel nuts. This service bulletin gives instructions on how to remove/install these wheel-nut caps correctly. |
NHTSA manufacturer communications (public domain)
NHTSA investigations
Seat Belt Buckle Casings may Fail
Seat belt latch failure
NHTSA Office of Defects Investigation