2001 Blue Bird ALL American

CERTAIN 2001 THROUGH 2006 MY BLUE BIRD ALL AMERICAN, TC2000, AND VISION TRANSIT SCHOOL BUSES MANUFACTURED BETWEEN JANUARY 5, 2001, AND JULY 15, 2005. THESE BUSES ARE EQUIPPED WITH A BATTERY DISCONNECT SWITCH THAT HAS CONNECTIONS THAT MAY BE LOOSE ON THE BATTERY SWITCH STUDS CREATING THE POTENTIAL FOR THE BUS TO SHUT DOWN WHILE IN OPERATION.

CERTAIN 2001 THROUGH 2005 ALL AMERICAN, COMMERCIAL SERIES, AND Q-BUS SCHOOL AND TRANSIT BUSES EQUIPPED WITH JOHN DEERE 8.1 CNG ENGINES. THE SUBJECT BUSES EQUIPPED WITH THE JOHN DEERE ENGINES MAY SURGE INAPPROPRIATELY DUE TO ERRACTIC OPERATION OF THE AIR THROTTLE IF THE ENGINE IS TAKEN FROM FULL TO ZERO LOAD.

CERTAIN 1998 THROUGH 2002 BLUE BIRD ALL AMERICAN, TC2000 SCHOOL AND TRANSIT BUSES, AND COMMERCIAL SERIES BUSES EQUIPPED WITH CUMMINS ISB DIESEL ENGINES. THE FUEL PUMP COULD FAIL TO TRANSFER FUEL APPROPRIATELY CREATING AN ENGINE STALL CONDITION.

CERTAIN SCHOOL BUSES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 221, "SCHOOL BUS BODY JOINT STRENGTH." ONE OR MORE OF THE BOLTS ATTACHING THE DRIVER'S PLATFORM TO THE FLOOR STRUCTURE WAS OMITTED.

ON CERTAIN REAR ENGINE (A3RE) SCHOOL BUSES, THE TYPE AND LOCATION OF THE FASTENERS USED TO RETAIN THE SEAT BELT IN THE LAST ROW OF SEATS DOES NOT CONFORM TO BLUE BIRD ENGINEERING SPECIFICATIONS.

ON CERTAIN SCHOOL BUSES EQUIPPED WITH OPTIONAL SEAT BELTS OR SEAT BELT "READY" SEATS, SOME BELTS WERE INSTALLED WITH ONLY TWO BOLTS RATHER THAN THE REQUIRED THREE (3) BOLTS.

ON CERTAIN SCHOOL AND TRANSIT BUSES EQUIPPED WITH PASSENGER SEAT BELTS WITH RETRACTORS, THE COVER HALVES FOR THE RETRACTABLE PORTION OF THE BELT CAN SEPARATE COMPLETELY AND RELEASE THE SEAT BELT CONNECTOR. IF THIS OCCURS, ONE OF THE LOAD BEARING PINS IN THE CONNECTOR COULD SEPARATE FROM THE CONNECTOR AND RENDER THE SEAT BELT UNUSABLE. IN THE EVENT OF A CRASH, THE SEAT OCCUPANT WOULD NOT BE PROPERLY RESTRAINED RESULTING IN AN INJURY. THE SEAT BELT SUPPLIER, AM-SAFE, WILL PROVIDE A SNAP ON "OVER-COVER" TO OWNERS TO PREVENT THE SEAT BELT COVER FROM SEPARATING.

CERTAIN TRANSIT BUSES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE STANDARD NO. 101, "CONTROLS AND DISPLAYS." THIS STANDARD REQUIRES SPECIFIC LABELING FOR "ENGINE START" AND "ENGINE STOP." THE WORDING OF THE LABELS ON THESE VEHICLES DO NOT MEET THE REQUIREMENTS OF THE STANDARD.

VEHICLE DESCRIPTION: SCHOOL BUSES EQUIPPED WITH HENDRICKSON REAR AIR SUSPENSION. INADEQUATE TIGHTENING OF THE 5/8" BOLTS ON THE REAR AIR SUSPENSION HANGER BOLTS AND ON REAR AXLE TORQUE ARM AXLE SEAT STUDS.

VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES. INSUFFICIENT TORQUE ON THE ARVIN-MERITOR AIR BRAKE CHAMBER MOUNTING NUTS CAN ALLOW THE NUTS TO LOOSEN OVER TIME.

VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES EQUIPPED WITH REAR MOUNTED ENGINES. THE 12-VOLT POWER SUPPLY CABLE(S) MAY BE CHAFFED BY HOSES, HARNESSES, FRAME COMPONENTS, OR CLAMPS.

VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES EQUIPPED WITH A COMBINATION SPICER J230 REAR AXLE, SPRING SUSPENSION, AND CREWSON BRUNNER AUTOMATIC SLACK ADJUSTERS. THE CREWSON BRUNNER SLACK ADJUSTER CONTACTS A U-BOLT MOUNTING BRACKET WHEN A COMBINATION OF THE LISTED COMPONENTS ARE INSTALLED. THE COMBINATION DOES NOT ALLOW FOR FULL EXTENSION OF THE SLACK ADJUSTER WHEN BRAKES ARE APPLIED.

VEHICLE DESCRIPTION: TRANSIT AND SCHOOL BUSES EQUIPPED WITH MERITOR WABCO PHASE 1, D-VERSION ANTILOCK BRAKE SYSTEM (ABS), FAIL TO COMPLY TO THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." AN INTERNAL DIAGNOSTIC SYSTEM IN THE ABS MAY NOT DETECT AN EXTREME WHEEL SPEED SENSOR AIR GAP. SUCH A CONDITION COULD POSSIBLY OCCUR DURING (1) ORIGINAL ASSEMBLY OR (2) SUBSEQUENT WHEEL END SERVICE.

VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES. THESE BUSES COULD HAVE IMPROPERLY INSTALLED OR MISSING PINCH BOLTS IN THE STEERING SHAFT ASSEMBLIES.

SCHOOL BUS STALLS