Year by year
| Model year | Complaints | Recalls |
|---|---|---|
| 2023 | 0 | 1 |
| 2009 | 0 | 0 |
| 2008 | 0 | 0 |
| 2007 | 1 | 0 |
| 2006 | 0 | 0 |
| 2005 | 1 | 2 |
| 2004 RE | 0 | 2 |
| 2003 | 0 | 4 |
| 2002 | 0 | 5 |
A model year gets its own page when it has enough data for at least three sections
Most common problems
- Service brakes, air1
- Equipment1
- Engine and engine cooling1
NHTSA ODI complaints, all model years
Recalls
9 campaigns cover the RE.
Navistar, Inc. (Navistar) is recalling certain 2023 IC CE and IN RE commercial buses. The fasteners that connect the transverse torque arm to the rear axle housing may have been tightened incorrectly, which can allow the rear axle to shift side to side.
CERTAIN 2005 MY INTERNATIONAL RE SCHOOL BUSES MANUFACTURED BETWEEN APRIL 1 AND JUNE 16, 2004 WHICH FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, AIR BRAKE SYSTEMS. TWO CHECK VALVES MAY NOT HAVE BEEN INSTALLED ON THE AIR TANKS TO ISOLATE THE PRIMARY AND SECONDARY AIR CIRCUITS. A LEAK OR FAILURE OF EITHER CIRCUIT MAY CAUSE THE SPRING BRAKES TO AUTOMATICALLY ACTUATE WITHOUT WARNING.
INTERNATIONAL 2005 MY RE SCHOOL BUSES BUILT FROM MARCH 3 THROUGH AUGUST 5, 2004. THE HIGH-PRESSURE SUPPLY HOSE FROM THE POWER STEERING PUMP TO THE STEERING GEAR MAY CHAFE AGAINST THE POSITIVE STUD ON THE STARTER SOLENOID. THE ENGINE ELECTRICAL HARNESS, CONTAINING THE POSITIVE CABLE FROM THE ALTERNATOR, MAY BE PINCHED BETWEEN THE ENGINE AND THE BUS BODY. AN OPTIONAL OIL PRESSURE SWITCH MAY HAVE BEEN DAMAGED DURING MANUFACTURING, CAUSING A LEAK TO FORM.
ON CERTAIN SCHOOL BUSES AND TRUCK MODEL VEHICLES MANUFACTURED BETWEEN FEBRUARY 28, 1999, THROUGH APRIL 5, 2004, THE ANTI-LOCK BRAKE SYSTEM ELECTRONIC CONTROL UNIT (ECU) MAY MISINTERPRET A CORRUPT WHEEL SPEED SIGNAL.
ON CERTAIN SCHOOL AND TRANSIT BUSES THE STUDS USED TO SECURE THE POWER STEERING PUMP TO THE ENGINE BLOCK CAN FAIL, RESULTING IN ENGINE OIL LEAKAGE AND COMPLETE LOSS OF POWER STEERING. THE POWER STEERING PUMP IS DESIGNED TO PROVIDE POWER ASSIST TO BOTH THE STEERING SYSTEM AND THE HYDRAULIC BRAKING SYSTEM. SHOULD STUD FAILURE CAUSE THE PUMP TO BECOME DISENGAGED FROM ITS DRIVE GEARS, A REDUCTION OF THE FLUID FLOW RATE TO THE BRAKE SYSTEM COULD OCCUR AND POSSIBLY CAUSE AN EXTENDED STOPPING DISTANCE AS WELL AS INCREASED STEERING WHEEL EFFORTS.
ON CERTAIN SCHOOL, TRANSIT, AND COMMERCIAL BUSES EQUIPPED WITH ADJUSTABLE STEERING COLUMNS, THE STEERING SHAFT PINCH BOLT INTERFERES WITH THE RUBBER BOOT THAT PROTECTS IT. OVER TIME, A HOLE MAY WEAR INTO THE BOOT AND CATCH THE BOLT.
ON CERTAIN SCHOOL AND TRANSIT BUSES BUILT WITH BOSCH ZERO OFFSET PIN SLIDE (ZOPS) HYDRAULIC DISC BRAKES, THE ZOPS HYDRAULIC DISC BRAKES MAY EXPERIENCE CALIPERS STICKING IN THE APPLIED POSITION, WHICH CAN RESULT IN EXCESSIVE OR ABNORMAL HEAT GENERATION AT ONE OR MORE OF THE BRAKES.
ON CERTAIN TRANSIT AND SCHOOL BUSES, A BRASS FITTING CONNECTS THE DOUBLE CHECK VALVE TO THE BRAKE RELAY VALVE. WITH CERTAIN INPUTS TO THE VEHICLE, THE WEIGHT OF THE CHECK VALVE ON THE FITTING CAN CAUSE THE ASSEMBLY TO RESONATE. THE SUBJECT VIBRATION CAN CAUSE EXCESSIVE STRAIN LEVELS IN THE FITTING, WHICH COULD EVENTUALLY FATIGUE AND FAIL.
VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES EQUIPPED WITH 39-INCH FLIP SEATS. THE FLIP SEATS COULD BIND IN THE OCCUPIED POSITION AND NOT RETURN TO THE STORED POSITION WHEN NOT OCCUPIED. THE CUSHION FRAME SUPPORT BAR SLIDES OFF THE SEAT SUPPORT PAD, WHICH COULD RETAIN THE SEAT IN THE OCCUPIED POSITION.
NHTSA recalls