New York safety inspections
At its first New York inspection the 2014 International Workstar failed the safety check 0.69% of the time — 70% less often than the average 2014 passenger car (2.30%). Median odometer at inspection: 47,635 miles.
NY DMV Vehicle Inspections (vezn-fmmk), initial inspections since Aug 2021 · how we count
Recalls in Canada
4 Transport Canada recalls for the 2014 International Workstar.
| 2015546 18 Nov 2015 | Engine On certain vehicles equipped with Navistar engines, the accelerator pedal position sensor could move on its mounting bracket if the pedal is depressed with exce… |
| 2015171 22 Apr 2015 | Electrical On certain vehicles, a double battery (24 volt) jump start or electrical load dump could result in an overvoltage condition of the linear power module (LPM) whi… |
| 2014574 17 Dec 2014 | Lights And Instruments Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. Headlight elec… |
| 2014141 22 Apr 2014 | Brakes On certain vehicles equipped with air disc brakes, the brake caliper bolts may have been insufficiently tightened, or an insufficient number of bolts may have b… |
Transport Canada Vehicle Recalls Database · Contains information licensed under the Open Government Licence – Canada
Recalls
Navistar, Inc. is recalling certain model year 2013-2014 International ProStar and DuraStar trucks manufactured April 26, 2012, to April 4, 2013, WorkStar trucks manufactured April 27, 2012, to March 29, 2013, LoneStar trucks manufactured May 21, 2012, to April 2, 2013, and TranStar trucks manufactured April 30, 2012, to March 25, 2013. In the affected vehicles, the accelerator pedal position sensor can move and result in a high engine idle.
Navistar, Inc. (Navistar) is recalling certain model year 2011-2015 International DuraStar, ProStar, TranStar and WorkStar, 2012-2015 International TerraStar, 2013-2015 International LoneStar and IC Bus HC, and 2014-2015 IC Bus AC vehicles. A vehicle double battery jump start or electrical load dump event could result in an overvoltage condition of a component within the HVAC system linear power module (LPM) which is used to control the blower speed. The overvoltage condition could result in the overheating and failure of the LPM.
Navistar, Inc. (Navistar) is recalling certain model year 2013-2015 International WorkStar vehicles manufactured March 16, 2012, to October 1, 2014. In the affected vehicles, the headlight low beam and ground circuits may have been reversed at the headlight connector resulting in reduced light output. As such, these vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) No. 108, "Lamps, Reflective Devices, and Associated Equipment."
Navistar, Inc. (Navistar) is recalling certain model year 2013-2015 International DuraStar vehicles manufactured November 2012 through December 2013, International WorkStar vehicles manufactured December 2012 through January 2014, and 2014-2015 International TranStar and International ProStar vehicles manufactured January 2013 through February 2014. The affected vehicles are built with air disc brake feature codes 04WEY, 04WEZ, or 04WZK. These vehicles may have an incorrect number of bolts mounting the brake caliper to the caliper mounting plate and some of the bolts may be improperly torqued.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What International told its dealers about the 2014 International Workstar: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 11010428 | This article addresses chassis lean conditions on all chassis. This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean. |
| 10253970 | This document details the procedure that must be followed to ensure proper alternator troubleshooting. |
| 10251414 | Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison transmission or PSI engine. |
| 10251409 | Suggested alignment target values when performing a vehicle axle alignment. |
| 10246231 | J1939 Data Link Source Address Information |
| 10244926 | Rebuilding Cylinder Heads on Certain MaxxForce 11/13, N13, and A26 engines; 2010 to present. |
| 10243610 | How to request a horsepower quote; all International and Cummins engines |
| 10243601 | Cummins B6.7 Grid Heater Relay |
| 10243596 | General Wheel Speed Sensor Troubleshooting |
| 10243595 | Diagnosis of chassis wander complaints. |
| 10241555 | J1939 Data Link Source Address Information |
| 10241554 | J1939 Data Link Troubleshooting |
| 10240193 | Snap-On torque wrench requirement for all big bore engine connecting rod bolts; A26, MaxxForce 13, N13 engines |
| 10237468 | New air compressor incorporates an oil feed dowel O-ring. Only models equipped with 2010 and newer MaxxForce 11/13 engines, all N13, and A26 engines |
| 10236042 | New Air compressor Incorporates an oil feed dowel O-ring; only models built with MaxxForce 11/13, N13, or A26 Engines |
| 10234021 | Rebuilding cylinder heads on certain EPA 2010 MaxxForce 11/13, N13, and A26 Engines |
| 10234015 | Cummins Programming guide and fault codes285 & 265; only vehicles built with Cummins B6.7, X15, or L9 engines |
| 10234000 | Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI engines or Cummins ISB engine with Allison transmissions |
| 10232616 | Rebuilding Cylinder Heads on Certain International MaxxForce 11/13 engines and all International N13 and A26 engines |
| 10227461 | Turbocharger oil supply tube retrofit; only models with 2010 emissions MaxxForce 11 and 13 engines and N13 engines |
| 10227455 | J1939 Data link source address information |
| 10222490 | Pico Scope CCOS (Crankcase Separator Test) |
| 10219330 | PicoScope Test One Channel RCT |
| 10219328 | PicoScope Wheel Speed Sensor Test |
| 10219325 | PicoScope Test Resistance and Ohmmeter |
NHTSA manufacturer communications (public domain)