Complaints by model year
Each bar is one model year. The most recent years are still collecting complaints.
NHTSA ODI complaints (public domain) · updated 23 Oct 2026
Year by year
| Model year | Complaints | Recalls |
|---|---|---|
| 2010 | 0 | 1 |
| 2009 | 0 | 2 |
| 2008 | 0 | 2 |
| 2007 | 0 | 1 |
| 2006 | 2 | 1 |
| 2005 | 2 | 2 |
| 2004 | 4 | 3 |
| 2003 | 4 | 3 |
| 2002 | 0 | 3 |
| 2001 | 0 | 1 |
| 2000 | 0 | 1 |
A model year gets its own page when it has enough data for at least three sections
Most common problems
- Suspension9
- Exterior lighting2
- Steering1
- Electrical system1
NHTSA ODI complaints, all model years
Recalls
10 campaigns cover the Cheetah.
KONGSBERG POWER PRODUCTS SYSTEMS I, INC., (KPPS) IS RECALLING ON BEHALF OF MONACO COACH CERTAIN MODEL YEAR 2008-2010 MOTOR HOMES MANUFACTURED AFTER APRIL 2007 AND EQUIPPED WITH PNEUMATIC AND HYDRAULIC ADJUSTABLE BRAKE PEDAL ASSEMBLIES SUPPLIED BY KPPS. THE DRIVE PIN WHICH SECURES THE BRAKE PEDAL ARM TO THE BALANCE OF THE ASSEMBLY MAY BECOME DISENGAGED, THIS MAY CAUSE A REDUCTION IN VEHICLE BRAKING AND/OR CAUSE THE BRAKE PEDAL TO MOVE OUT OF POSITION AND INTERFERE WITH THROTTLE PEDAL FUNCTION.
MONACO IS RECALLING 238 MY 2008-2009 SAFARI CHEETAH, BEAVER CONTESSA, AND MY 2009 MONTEREY CLASS A MOTORHOMES EQUIPPED WITH C7 OR C9 CATERPILLAR DIESEL ENGINES. THE FUEL PUMP OUTLET CHECK PLUG MAY BE CRACKED WHICH COULD CAUSE FUEL TO SPRAY AND LEAK.
ON CERTAIN MOTOR HOMES, FIFTH WHEEL AND TRAVEL TRAILERS EQUIPPED WITH A TWO-DOOR REFRIGERATOR MANUFACTURED BY THE DOMETIC CORPORATION, THE REFRIGERATOR MAY HAVE A DEFECT IN THE BOILER TUBE. PRESSURIZED COOLANT SOLUTION COULD BE RELEASED INTO AN AREA WHERE AN IGNITION SOURCE (GAS FLAME) IS PRESENT.
ON CERTAIN MOTOR HOMES EQUIPPED WITH ATWOOD SEALED BURNER RANGES, THE RANGE AND SLIDE-IN BURNER TUBES LEADING FROM THE GAS MANIFOLD TO THE BURNER HEADS HAD A DEPRESSION OR 'KINK' IN THE EXTERIOR BEND RESTRICTING PROPER AIRFLOW AND GAS MIXTURE.
CERTAIN MOTOR HOMES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, 'AIR BRAKE SYSTEMS.' TWO DELIVERY LINES ON THE BRAKE SYSTEM WERE INSTALLED INCORRECTLY.
ON CERTAIN CLASS A MOTOR HOMES, THE SPACER PLATE UNDER THE TRAILING ARMS HAD A TRANSVERSE WELD WHICH CREATES A HEAT RISER AND CAUSE THE TRAILING ARMS TO CRACK.
ON CERTAIN MOTORHOMES, THE I-BEAM LEAF IMITATOR IN THE FRONT AXLE SUSPENSION COULD CRACK AND BREAK DUE TO AN INADEQUATE WELDING PROCESS.
CERTAIN 36', 38', AND 40' MOTOR HOMES FAIL TO COMPLY WITH REQUIREMENTS OF PART 567, "CERTIFICATION." THE REAR PSI STATES 85 OR 115 LBS. THE CORRECT REAR PSI IS 95 LBS.
ON CERTAIN MOTOR HOMES, THE BRAKE ASSEMBLIES EXHIBIT ELEVATED TEMPERATURES THAT CAN LEAD TO CATASTROPHIC DETERIORATION OF THE WHEEL END COMPONENTS SUCH AS BEARINGS, RACES, SPINDLES, KNUCKLES, SEALS, HUBS, ROTORS, PATCH BOLTS, CALIPERS, BRAKE PADS, AND ABS SENSORS.
ON CERTAIN MOTOR HOMES EQUIPPED WITH ELECTRONIC THROTTLE CONTROL/ACCELERATOR PEDALS SUPPLIED BY WILLIAMS CONTROLS INDUSTRIES, THE WELD ATTACHING THE CLEVIS TO THE PLATE HAS INSUFFICIENT PENETRATION AND COULD ALLOW THE CLEVIS TO SEPARATE FROM THE PLATE.
NHTSA recalls