Complaints by model year
Each bar is one model year. The most recent years are still collecting complaints.
NHTSA ODI complaints (public domain) · updated 23 Oct 2026
Year by year
| Model year | Complaints | Recalls |
|---|---|---|
| 2002 WIA | 0 | 1 |
| 2001 | 0 | 1 |
| 2000 | 0 | 1 |
| 1999 | 1 | 1 |
| 1998 | 1 | 4 |
| 1997 WIA | 8 | 6 |
| 1996 WIA | 8 | 7 |
| 1995 WIA | 7 | 4 |
| 1994 WIA | 0 | 3 |
| 1993 WIA | 3 | 2 |
| 1992 | 0 | 2 |
| 1991 | 0 | 2 |
| 1990 | 0 | 2 |
| 1989 | 1 | 1 |
| 1988 | 0 | 1 |
A model year gets its own page when it has enough data for at least three sections
Most common problems
- Suspension20
- Electrical system9
- Power train7
- Structure6
- Steering6
- Engine and engine cooling6
- Visibility3
- Unknown or other3
NHTSA ODI complaints, all model years
Recalls
12 campaigns cover the WIA.
CERTAIN HEAVY DUTY CLASS 8 TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE TWO TAIL LAMPS, BACK-UP LAMP,AND LICENSE TAG LAMP WERE MOUNTED ON INSUFFICIENTLY RIGID MOUNTS.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH HALDEX MANIFOLD DASH VALVES (MDV) USED IN TRACTOR AND TRAILER PARKING BRAKES. THESE VALVES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." A LOSS OF THE ISOLATION OF THE TWO BRAKE SYSTEM CIRCUITS CAN RESULT IN THE LOSS OF SERVICE BRAKES WHEN THERE IS ANOTHER FAILURE OF ONE OF THE TWO BRAKE CIRCUITS.
VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH FONTAINE FIFTH WHEEL ASSEMBLIES, MODELS SL5WMS6125, SL5WMS7125, SL5WMS8125, SL5WMS9125, SL5WMS10125, SL5APM6125, SL5APM7125, SLAPM8125, SL5APM9125, SL5APM10125, SL5WMS-D, SL5APM-D, AND SL5BPS-D. IMPROPER INSTALLATION OF THE FIFTH WHEEL ASSEMBLY CAN CAUSE CRACKING OF THE FIFTH WHEEL MOUNTING PLATE.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE AIR SUSPENSION CONTROL VALVE SUPPLY LINE WAS NOT PLUMBED THROUGH AN AIR PRESSURE PROTECTION VALVE. IN THE EVENT OF A FAILURE, THERE WOULD BE LOSS OF AIR PRESSURE IN THE 'B' SYSTEM AIR RESERVOIR THAT SUPPLIES AIR PRESSURE FOR THE FRONT STEER AXLE BRAKES.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH DESIGN LEVEL 1, ROCKWELL FF980 SERIES FRONT AXLE. THE FRONT AXLE HUB FLANGE CAN DEVELOP CRACKS DUE TO HIGH STRESS LEVELS.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE STEER AXLE WHEEL BEARING JAM NUT LOCK WASHER MAY NOT HAVE BEEN BENT OVER THE JAM NUT AFTER THE WHEEL BEARINGS WERE ADJUSTED.
WARNING LABELS IDENTIFYING THE CLIMBING SEQUENCE AND PROCESS WERE OMITTED.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY VEHICLES EQUIPPED WITH EATON DRIVE AXLES AND AXILOK SPINDLE NUTS. THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.
THE TRACTION SOLENOID EXHAUST CAN BE OBSTRUCTED DUE TO INADEQUATE DRAINAGE AND A BUILD-UP OF ROAD CONTAMINATION BETWEEN THE MOUNTING BRACKET AND THE SOLENOID HOUSING. THE OBSTRUCTED EXHAUST PREVENTS THE RELAY VALVE CONTROL AIR PRESSURE FROM VENTING AFTER A DIFFERENTIAL BRAKING TRACTION EVENT.
VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 VEHICLES BUILT WITH A VOLVO 5.7 (12,500 LBS) FRONT STEERING AXLE. DUE TO HYDROGEN EMBRITTLEMENT, THE FRONT STEERING AXLE KING PINS COULD HAVE BROKEN DURING ASSEMBLY. CONTINUED OPERATION OF A VEHICLE WITH A BROKEN KING PIN COULD ALLOW THE PIN TO WORK LOOSE.
THE REAR SUSPENSION AXLE RETENTION PLATE CAN BREAK UNDER NORMAL USE, AFFECTING AXLE ALIGNMENT.
NHTSA recalls