Complaints by model year
Each bar is one model year. The most recent years are still collecting complaints.
NHTSA ODI complaints (public domain) · updated 23 Oct 2026
Year by year
| Model year | Complaints | Recalls |
|---|---|---|
| 1999 | 0 | 0 |
| 1998 F800 | 6 | 2 |
| 1997 | 6 | 0 |
| 1996 | 1 | 0 |
| 1995 | 2 | 4 |
| 1994 | 0 | 2 |
| 1993 | 0 | 3 |
| 1992 | 0 | 2 |
| 1991 | 1 | 1 |
| 1990 F800 | 1 | 1 |
| 1989 | 0 | 0 |
| 1988 | 0 | 0 |
| 1987 | 0 | 0 |
| 1986 | 0 | 0 |
| 1985 | 0 | 0 |
| 1984 | 0 | 1 |
| 1983 | 0 | 2 |
| 1982 | 0 | 0 |
| 1981 | 0 | 3 |
A model year gets its own page when it has enough data for at least three sections
Most common problems
- Power train4
- Engine and engine cooling4
- Service brakes, hydraulic3
- Vehicle speed control2
- Structure2
- Fuel system, gasoline2
- Tires1
- Suspension1
NHTSA ODI complaints, all model years
Recalls
16 campaigns cover the F800; the latest 12 are below.
VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS AND CHASSIS-CABS. AN AUTOMATIC LOCKING FRONT WHEEL BEARING ADJUSTING NUT WAS DAMAGED DURING INSTALLATION OR REMOVAL BY INCORRECT TOOLS OR AN INCORRECT TORQUE SPECIFICATION WAS USED.
VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS AND SCHOOL BUS CHASSIS-COWLS EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THE WELDS THAT ATTACH THE KEY TO THE TOP OF THE STEERING COLUMN MOUNTED AUTOMATIC TRANSMISSION SHIFT LINKAGE MAY NOT ADEQUATELY RETAIN THE KEY, ALLOWING THE TRANSMISSION TO BE IN A GEAR OTHER THAN THAT INDICATED ON THE "PRNDL", OR IN SOME CASES, "RNDL."
THE HAND THROTTLE CABLE CAN WEAR THE BRASS SWIVEL BLOCK ON THE GOVERNOR LEVER THROUGH WHICH IT PASSES.
A CONNECTOR IN THE WIRING WHERE THE TILT HOOD MOUNTED LAMPS ATTACH TO THE VEHICLE WIRING HARNESS WAS BUILT WITHOUT SEALING PLUGS. MOISTURE, ROAD SALT OR OTHER CONTAMINANTS CAN ENTER THE CONNECTION RESULTING IN CROSSED CIRCUITS, SHORTS OR CORROSION OF THE WIRING OF THE CONNECTOR.
THE DRAG LINK INSTALLED CAN CONTACT THE FRONT AXLE I-BEAM UNDER CERTAIN EXTREME CONDITIONS. THIS DRAG LINK WAS NOT INTENDED TO BE INSTALLED ON "LOW PROFILE" VEHICLES.
THE VEHICLES WERE MANUFACTURED WITHOUT SEPARATE ABS INDICATOR LAMPS. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS."
AS A RESULT OF INHERENT VIBRATION IN THESE ENGINES, THE THROTTLE RETURN SPRINGS CAN FRACTURE.
WATER CAN ENTER THE DOOR LATCH RELEASE CABLE. IF THE VEHICLE IS OPERATED IN BELOW FREEZING TEMPERATURES, THE WATER IN THE DOOR LATCH RELEASE CABLE CAN FREEZE AND CAUSE THE LATCH MECHANISM TO MALFUNCTION.
THE THROTTLE CABLE WHICH RUNS FROM THE ACCELERATOR TO THE GOVERNOR ASSEMBLY HOUSING MAY HAVE BEEN KINKED DURING ASSEMBLY, CAUSING EXCESSIVE WEAR OF THE CABLE HOUSING INNER LINING. THIS COULD RESULT IN EITHER FRACTURE OR STICKING OF THE CABLE.
THE INVOLVED VEHICLES WERE PRODUCED WITH HYDRAULIC BRAKE BOOSTER SUPPLY HOSES THAT ARE LOCATED TOO CLOSE TO THE ENGINE EXHAUST MANIFOLD AND MAY CHAFE AND DEVELOP HEAT DAMAGE DURING VEHICLE OPERATION. CHAFING AND HEAT INDUCED DETERIORATION OF A HOSE DUE TO DIRECT CONTACT WITH THE MANIFOLD MAY CAUSE THE HOSE TO WEAR. A SUBSEQUENT RUPTURE WILL RESULT IN PUMP FLUID LOSS.
TWO-INCH SPACERS SPECIFIED FOR INSTALLATION BETWEEN THE FRONT AXLES AND EACH FRONT SPRING ASSEMBLY WERE OMITTED DURING MANUFACTURE. UNDER CERTAIN TURNING AND BOUNCING CONDITIONS, A FRONT TIRE COULD CONTACT ADJACENT VEHICLE COMPONENTS, RESULTING IN A POSSIBLE SEPARATION OF THE DRAG LINK TO STEERING ARM BALLJOINT OR LOSS OF TIRE PRESSURE.
NHTSA recalls