Problems owners report
Complaints filed with NHTSA about the 2007 Volvo VT, by the system named in each complaint. One complaint can name several.
- Visibility1
NHTSA ODI complaints (public domain) · updated 23 Oct 2026 · 0 injuries and 0 deaths reported
Compared with other years
NHTSA ODI complaints by model year
Recalls in Canada
9 Transport Canada recalls for the 2007 Volvo VT.
| 2013221 25 Jun 2013 | Other On certain vehicles, the secondary clutch disengagement switch may have been omitted during vehicle assembly or, in some instances, removed during servicing. A… |
| 2010433 6 Dec 2010 | Other On certain trucks equipped with an air release fifth wheel hitch, the inversion valve on the frame may be orientated where contaminants can enter the valve thro… |
| 2009144 19 May 2009 | Other On certain vehicles, the windshield wiper motor may be susceptible to water intrusion, which could result in an electrical short circuit and a fire. This could… |
| 2007394 10 Dec 2007 | Electrical On certain trucks, the automatic circuit breakers used to protect the vehicle lighting system may not provide adequate protection. If a short circuit occurs, c… |
| 2007338 19 Oct 2007 | Other On certain trucks, the fifth wheel hitch assembly's lever arm may have been incorrectly installed during the manufacturing process. The lever arm pivot bolt ma… |
| 2007257 7 Aug 2007 | Fuel System On certain trucks, when the ignition key is in the 'ON' position, the pre-heater, located in the fuel filter base, is energized. If this pre-heater is energize… |
| 2007253 25 Jul 2007 | Steering On certain trucks, the locknut used to retain the steering shaft may not have had the lock feature. As a result, the nut could loosen, allowing the steering sh… |
| 2006243 29 Sept 2006 | Powertrain On certain trucks, an improperly seated or missing u-joint snap ring can result in the bearing cup to separate from the slip yoke sub-assembly. The u-joint cou… |
| 2006072 31 Mar 2006 | Steering On certain vehicles, the steering shaft pinch bolt hole may be incorrectly located. As a result, the steering shaft may separate from the steering gear which c… |
Transport Canada Vehicle Recalls Database · Contains information licensed under the Open Government Licence – Canada
Recalls
Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.
VOLVO TRUCKS IS RECALLING CERTAIN MODEL YEAR 2007 AND 2009 VHD, MODEL YEAR 2006 THROUGH 2010 VN, AND MODEL YEAR 2007 THROUGH 2009 VT TRUCKS MANUFACTURED FROM NOVEMBER 7, 2005, THROUGH OCTOBER 30, 2009, EQUIPPED WITH AN AIR RELEASE FIFTH WHEEL. THE INVERSION VALVE ON THE FRAME MAY BE ORIENTATED WHERE CONTAMINANTS CAN ENTER THE VALVE THROUGH THE EXHAUST PORT. AS A RESULT, THE BRAKE VALVE MAY CORRODE.
VOLVO TRUCKS IS RECALLING 127,764 MY 2001-2008 VHD, VNL, VNM, AND MY 2005-2008 VT TRUCKS. A SEAL MAY FAIL ALLOWING WATER AND CONTAMINANTS TO SEEP INTO THE WINDSHIELD WIPER MOTOR.
ON CERTAIN HEAVY DUTY TRUCKS, THE CIRCUIT PROTECTION (I.E. AUTOMATIC CIRCUIT BREAKERS) USED TO PROTECT THE VEHICLE LIGHTING SYSTEM MAY NOT PROVIDE ADEQUATE PROTECTION.
ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PIN.
ON CERTAIN TRUCKS, AN UNPROTECTED LEAD IN THE THERMOSWITCH OF THE HEATER MAY MAKE CONTACT WITH ANOTHER POST POSSIBLY CREATING A SHORT CIRCUIT, WHICH CAN RESULT IN CONTINUOUS OPERATION OF THE HEATING ELEMENT.
ON CERTAIN TRUCKS, THE NUT USED TO RETAIN THE STEERING SHAFT MAY OR MAY NOT BE A LOCK NUT THAT HAS THE LOCKING FEATURE. A LOCK NUT IS REQUIRED TO PROVIDE ADDITIONAL RESISTANCE TO ENSURE THAT THE NUT DOES NOT COME LOOSE.
ON CERTAIN TRUCKS EQUIPPED WITH ARVINMERITOR RPL20 HIGH ANGLE INTERAXLE DRIVESHAFTS, AN IMPROPER SEATED OR MISSING SNAP RING CAN RESULT IN THE BEARING CUP TO SEPARATE FROM THE SLIP YOKE SUB-ASSEMBLY. THE UNIVERSAL JOINT CROSS COULD THEN CONTACT THE SLIP YOKE CASTING AND EVENTUALLY CAUSE THE EAR WORK TO FRACTURE.
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING GEAR IF THE PINCH BOLT COMES LOOSE.
Whether a recall was fixed on a particular car is known only to the manufacturer: check the VIN at nhtsa.gov/recalls.
NHTSA recalls · summaries in NHTSA's own words
Service bulletins
What Volvo told its dealers about the 2007 Volvo VT: known faults, fixes and updates.
| Bulletin | Summary |
|---|---|
| 10251319 | CBR - Automated Manual Transmission ( AMT ) Flywheel Pilot Bearing Wear On Input Shaft. |
| 10225704 | Volvo Chassis - ( AMT, I-Shift ) - Transmission Grinding When Downshifting ; Range Synchronizer (Synchro) Timing Procedure - US07 And Newer |
| 10222270 | TSB-Charge Air Cooler t-clamp install. |
| 10219421 | Engine Control Module (EMS) Software (MSW) Information August 2022; Improvement List (Change Log) - US21+OBD22 (13L VGT, TC) And US17+OBD22 (11L) Emissions |
| 10215308 | Volvo Chassis - Equipped with An Automated Manual Transmission (AMT, iShift) - SNV 19-002 - AMT Oil Filter Housing Corrosion |
| 10215306 | Volvo Chassis - Drag Link Inspection And Replacement Criteria |
| 10215283 | AMT Control Housing Bench Testing - False Failures |
| 10215282 | DEF Level (UQLS) Sensor Troubleshooting Guide - US17+OBD16 Emissions and Newer |
| 10215281 | Programming Failure - Chassis With Cummins Engine And An Allison Transmission |
| 10215279 | NOx Sensor Troubleshooting Guide - US10+OBD13 And Newer Emissions |
| 10215277 | DTC U012100 - Lost Communication With Anti-Lock Brake System (ABS) Control Module, No Additional Information |
| 10215276 | (Back Office) - Cruise Control Inoperative After Updating Software VECU5 Without ESP Package (UESP) |
| 10215271 | DEF Pump Troubleshooting Guide - US10+OBD13 And Newer Emissions |
| 10215270 | Temperature Sensor Troubleshooting Guide - US10+OBD13 And Newer |
| 10215265 | Warranty Automated Manual Transmission ( AMT, I-Shift, mDrive ) Control Housing Assembly; Guidelines For Filing A Claim For Chassis Return Visit With Transmission Issues After A Repair Requiring Control Housing Removal And Reinstallation - US07 And Newer |
| 10215263 | Unable To Retrieve "On Request" Messages For PeopleNet Or Omnitracs Modules Installed On The DL5 Data Link; Third Party Electronic Log Device Not Reporting Certain Data |
| 10213665 | Sensor And Parameter Values Missing Or Reading Zero When Performing A Sensor And Parameter Values Monitor With Premium Tech Tool ( PTT ) - US07 And US10 ( Pre-OBDII, 9-Pin Diagnostic Connector ) Chassis |
| 10213631 | DEF Level (UQLS) Sensor Troubleshooting Guide - US17+OBD16 Emissions and Newer |
| 10213604 | Fuel Level Gauge Reading Incorrect In The Instrument Cluster |
| 10213526 | The Diagnostic Process |
| 10213524 | Volvo I-Shift AMT Will Not Calibrate After Incorrect Flywheel Housing Is Installed |
| 10213519 | Volvo Fault Code MID 144 PSID 204 FMI 9 |
| 10213518 | Volvo SNV15-008 Vocom Adapter ( 88890300 ) May Lock Up When Updating Firmware |
| 10213516 | Volvo Chassis - Dealer Support Communication - Selecting The Proper SR Area For Creating An eService |
| 10213514 | Volvo Chassis - Bendix ABS6 TO ABS8 Service Information |
NHTSA manufacturer communications (public domain)
NHTSA investigations
Stop Lamp Switch Signal
Volvo Sleeper glass de-bonding
SAF HOLLAND FIFTH WHEEL ASSEMBLY
NHTSA Office of Defects Investigation