2008 Sterling L-Line

DAIMLER TRUCKS IS RECALLING CERTAIN MODEL YEAR 2004 THROUGH 2008 HEAVY TRUCKS MANUFACTURED FROM JULY 11, 2003, THROUGH SEPTEMBER 28, 2007, EQUIPPED WITH EPA04 MODEL MBE4000 ENGINES BUILT WITH PLASTIC LOW PRESSURE FUEL LINES AND FUEL FILTERS MOUNTED NEAR THE CENTER OF THE ENGINE ON THE LEFT-HAND SIDE. THE PLASTIC LOW PRESSURE FUEL LINE BETWEEN ENGINE MOUNTED FUEL FILTER AND ENGINE BLOCK MAY DEVELOP A SUBSTANTIAL DIESEL FUEL LEAK.

DTNA IS RECALLING CERTAIN MODEL YEAR 2008-2012 FREIGHTLINER; CASCADIA, CENTURY CLASS, COLUMBIA, AND CORONADO, CERTAIN MODEL YEAR 2008-2009 STERLING; A-LINE AND L-LINE AND CERTAIN MODEL YEAR 2009-2012 WESTERN STAR CONSTELLATION VEHICLES, MANUFACTURED FROM JANUARY 14, 2008, THROUGH JUNE 15, 2011, BUILT WITH DETROIT DIESEL 15 OR 16 ENGINES. THE BOLT ATTACHING A RUBBER ISOLATOR TO A SUPPORT BRACKET MAY BECOME LOOSE AND BACK OUT, POTENTIALLY CONTACTING AN UN-FUSED STARTER CABLE AND CREATING A SHORT CIRCUIT.

DAIMLER TRUCKS IS RECALLING MODEL YEAR 2004-2010 TRUCKS EQUIPPED WITH CATERPILLAR C15 ENGINE. THE VARIABLE VALVE ACTUATION OIL LINE MAY RUB AGAINST THE P-CLIPS RETAINING THE OIL LINE, CAUSING AN OIL LEAK.

DAIMLER TRUCKS IS RECALLING 2 MY 2008-2009 FREIGHTLINER COLUMBIA AND STERLING L-LINE TRUCKS EQUIPPED WITH CATERPILLAR C7, C9, C13 AND C15 DIESEL ENGINES. INADEQUATE STIFFNESS OF THE DIESEL PARTICULATE FILTER (DPF) BRACKET COULD RESULT IN SEPARATION OF THE DPF FROM THE CHASSIS.

CATERPILLAR IS RECALLING 14 MY 2008-2009 STERLING A-LINE & L-LINE TRUCKS EQUIPPED WITH CATERPILLAR ENGINE. THE AFTERTREATMENT REGENERATION DEVICE (ARD) MAY DEVELOP A HOLE AND HEAT AND FLAME MAY ESCAPE DURING A REGENERATION OF THE DIESEL PARTICULAR FILTER.

DAIMLER TRUCKS IS RECALLING 900 MY 2008 FREIGHTLINER ARGOSY, ARGOSY RHD, CASCADIA, COLUMBIA, CENTURY ST, CORONADO, STERLING ACTERRA, L-LINE AND WESTERN STAR 4900 TRUCKS EQUIPPED WITH BENDIX MV-3 DASH CONTROL VALVES. THE MOLDED VALVE BODY HAS AN INCORRECT CORE PIN IN THE INJECTION MOLD CAUSING THE VALVE BODY TO BE OVERSIZED IN THE DOUBLE CHECK VALVE AREA. THIS CONDITION CAN ALLOW THE RUBBER DOUBLE CHECK VALVE TO BECOME LODGED IN THE BODY OPENING UNDER CERTAIN CIRCUMSTANCES.

ON CERTAIN TRUCKS EQUIPPED WITH TRW STEERING GEARS, MODELS TAS85 AND RCS85, THESE STEERING GEARS CONTAIN POTENTIALLY DEFECTIVE SECTOR SHAFTS WITH AN INCORRECT GEAR TOOTH WHICH MAY INTERFERE WITH THE RACK-PISTON TEETH, RESULTING IN A STICK OR BIND CONDITION.

ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.

ON CERTAIN TRUCKS BUILT WITH AXILOK REAR WHEEL SPINDLE NUTS, THE NUTS MAY HAVE BEEN IMPROPERLY INSTALLED, WITH ONE OR BOTH LOCKING CLIP TABS NOT PROPERLY ENGAGED OR DAMAGED.

FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED.

CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

INSECURE FIFTH WHEEL LATCHING