Ford Crown Victoria

Ford Motor Company (Ford) is recalling certain model year 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles manufactured October 3, 2001, to August 2, 2005. The affected vehicles have a lighting control module (LCM) that may fail, resulting in a loss of headlights.

Ford Motor Company (Ford) is recalling certain model year 2005-2011 Ford Crown Victoria, 2005-2011 Mercury Grand Marquis vehicles manufactured March 23, 2004, to August 30, 2011, and 2005-2011 Lincoln Town Car vehicles manufactured March 8, 2004, to August 30, 2011, and on which the upper intermediate shaft was serviced during the course of safety recall 13V-385. The prior repairs may not have been correctly performed.

Ford is recalling certain model year 2005-2011 Ford Crown Victoria (including Crown Victoria Police Interceptors), Mercury Grand Marquis, and Lincoln Town Car vehicles. The affected vehicles are currently registered or were originally sold in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. Severe corrosion can seize the lower intermediate shaft which may cause the upper intermediate shaft to collapse and the steering column lower bearing to separate.

FORD IS RECALLING 225,000 MY 1992-2003 ECONOLINE, MY 1993-1995 TAURUS SHO, MY 1992-1998 CROWN VICTORIA, MY 1993 BRONCO, F-SERIES, MY 1995-1997 F-SERIES SUPER DUTY STRIPPED CHASSIS, MY 1992-1998 MERCURY GRAND MARQUIS, AND MY 1992-1995 LINCOLN TOWN CAR VEHICLES. THE AFFECTED VEHICLES WERE PREVIOUSLY REPAIRED USING A WIRING HARNESS THAT IS NOT COMPATIBLE WITH THE VEHICLE CIRCUIT POLARITY.

ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

ON CERTAIN PASSENGER VEHICLES, A FRONT WHEEL BEARING AND HUB ASSEMBLY MAY FRACTURE DUE TO IMPROPER HEAT TREATMENT.

CERTAIN PASSENGER VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEMS (ABS) FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKE SYSTEMS." THE FRONT AND REAR RIGHT SIDE BRAKE LINES MAY BE REVERSED AT THE ABS HYDRAULIC CONTROL UNIT.

CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, 'WINDSHIELD MOUNTING.' THE WINDSHIELD MAY NOT BE PROPERLY SECURED TO THE VEHICLE BODY.

ON CERTAIN PASSENGER VEHICLES, THE BATTERY CABLE INCLUDES A FUSIBLE LINK THAT MAY CONTACT AND SUBSEQUENTLY CHAFE ON A #2 CROSS MEMBER ATTACHING BOLT.

ON CERTAIN POLICE INTERCEPTORS (CVPI) AND COMMERCIAL HEAVY DUTY (TAXI) VEHICLES, AT EXTREMELY HIGH OPERATING TEMPERATURES, THE SOUND INSULATING PANEL, LOCATED UNDER THE VEHICLE POSITIONED BETWEEN THE EXHAUST SYSTEM AND THE UNDERBODY, COULD SAG AND POSSIBLY CONTACT THE SURFACE OF THE CATALYTIC CONVERTER.

ON CERTAIN PASSENGER VEHICLES BUILT WITH ELECTRONIC TRACTION CONTROL, THE REAR BRAKE LINE MAY CHAFE DUE TO CONTACT BETWEEN IT AND A FLOOR PAN STIFFENING RIB, AND A BRAKE FLUID LEAK MAY OCCUR.

CERTAIN POLICE, COMMERCIAL, AND PASSENGER VEHICLES SOLD TO FLEETS TYPICALLY INPUT HIGHER LOADS INTO THE VEHICLE CHASSIS OVERLOADING THE WHEEL BEARINGS AND AXLES.