2008 Freightliner Business Class M2

Daimler Trucks North America LLC (DTNA) is recalling certain 2006-2020 Freightliner Columbia, 2006-2021 Freightliner Business Class M2, 2007-2020 Freightliner Coronado, 2014-2021 Freightliner 122 SD, 2007 Sterling A 9500, 2006 Freightliner Argosy, 2006-2007 Sterling AT9500, 2008-2021 Freightliner Cascadia, 2006-2008 Freightliner Classic, 2006-2011 Freightliner Century Class, 2006-2010 Freightliner FLD, and 2017 Western Star 5700 vehicles. The rear reflective tape may be partially covered by the mudflap hanger bracket, which may reduce the vehicle's visibility to other drivers on the road. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

DAIMLER TRUCKS (DTNA) IS RECALLING CERTAIN MODEL YEAR 2006-2013 FREIGHTLINER, STERLING, AND WESTERN STAR VEHICLES, EQUIPPED WITH DETROIT DIESEL EPA07 AND EPA10, DD13 AND DD15/16 ENGINES, MANUFACTURED FROM JANUARY 20, 2006, THROUGH FEBRUARY 20, 2012. THE PUMP TO RAIL HIGH PRESSURE FUEL LINE SUPPORT SYSTEM USED ON THESE ENGINES IS SENSITIVE TO ASSEMBLY TORQUE AND MAY BE DAMAGED DURING SERVICE WORK. AS A RESULT OF OTHER REPAIRS, THE LINE SUPPORTS MAY LOOSEN, POTENTIALLY LEADING TO FUEL LINE CRACKING AND A FUEL LEAK.

DAIMLER TRUCKS IS RECALLING CERTAIN MODEL YEAR 2004 THROUGH 2008 HEAVY TRUCKS MANUFACTURED FROM JULY 11, 2003, THROUGH SEPTEMBER 28, 2007, EQUIPPED WITH EPA04 MODEL MBE4000 ENGINES BUILT WITH PLASTIC LOW PRESSURE FUEL LINES AND FUEL FILTERS MOUNTED NEAR THE CENTER OF THE ENGINE ON THE LEFT-HAND SIDE. THE PLASTIC LOW PRESSURE FUEL LINE BETWEEN ENGINE MOUNTED FUEL FILTER AND ENGINE BLOCK MAY DEVELOP A SUBSTANTIAL DIESEL FUEL LEAK.

DAIMLER TRUCKS IS RECALLING CERTAIN MODEL YEAR 2008 AND 2009 FREIGHTLINER BUSINESS CLASS M2 AND STERLING ACTERRA EMERGENCY VEHICLES MANUFACTURED FROM AUGUST 18, 2006, THROUGH JULY 7, 2010, EQUIPPED WITH EPA 2007 MBE 900 DETROIT DIESEL ENGINES. ENGINE SOFTWARE MAY NOT REACT PROPERLY TO CERTAIN AFTERMARKET TREATMENT DEVICE FAULT CODES. THE SOFTWARE MAY UNNECESSARILY SHUTDOWN A VEHICLE OR MAY FAIL TO SHUTDOWN A VEHICLE WITH AN AFTERMARKET DEVICE OVER-TEMP FAULT.

DAIMLER TRUCKS IS RECALLING CERTAIN MODEL YEAR 2007 THROUGH 2010 FREIGHTLINER BUSINESS CLASS M2, CUSTOM CHASSIS MT45, S2 CHASSIS, AND STERING ACTERRA VEHICLES MANUFACTURED FROM OCTOBER 5, 2006, THROUGH MAY 24, 2010, EQUIPPED WITH EPA 2007 MBE 900 DETROIT DIESEL ENGINES. ENGINE SOFTWARE MAY NOT REACT PROPERLY TO CERTAIN AFTERMARKET TREATMENT DEVICE FAULT CODES. THE SOFTWARE MAY UNNECESSARILY SHUTDOWN A VEHICLE OR MAY FAIL TO SHUTDOWN A VEHICLE WITH AN AFTERMARKET DEVICE OVER-TEMP FAULT.

DTNA IS RECALLING CERTAIN MODEL YEAR 2005 THROUGH 2011 FREIGHTLINER BUSINESS CLASS C2, FCCC B2 CHASSIS, S2 CHASSIS, AND MC CHASSIS MANUFACTURED BEGINNING JANUARY 19, 2005 THROUGH APRIL 16, 2010. THE STOP LAMPS MAY BE INTERMITTENT DURING LIGHT BRAKE APPLICATIONS.

DAIMLER TRUCKS IS RECALLING 172 MY 2008-2009 BUSINESS CLASS M2 106 ALL WHEEL DRIVE VEHICLES EQUIPPED WITH CUMMINS ISC ENGINES AND HIGHWAY HOODS. THESE VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, 'LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.' THE HEADLIGHTS MEASURE GREATER THAN 54" FROM THE ROAD SURFACE WHICH DOES NOT MEET THE STANDARD REQUIREMENTS.

DAIMLER TRUCKS IS RECALLING 28,764 MY 2001 THROUGH 2008 FCCC B2 AND FS65 SCHOOL BUS CHASSIS, FCCC FB65 CONVENTIONAL BUSES, AND STERLING ACTERRA, FREIGHTLINER FLN, AND BUSINESS CLASS M2 HEAVY TRUCKS, BUILT FROM JANUARY 26, 2000, THROUGH MARCH 24, 2008, MANUFACTURED WITH ARVINMERITOR OR AXLE ALLIANCE COMPANY 6,000 THROUGH 8,000 POUND FRONT AXLES UTILIZING A FOUR PIECE SPINDLE-NUT SET. THESE AXLE ASSEMBLIES MAY HAVE BEEN PRODUCED WITH A THIN SPINDLE NUT WHICH MAY LEAD TO INCORRECT END PLAY, CONE SPIN, EXCESSIVE HEAT, DEGRADATION OF LUBRICATION, WEAR OF THE SPINDLE NUT AND BEARING JOURNAL, OIL CONTAMINATION WITH METAL SHAVINGS, AND PREMATURE BEARING FAILURE.

ON CERTAIN TRUCKS EQUIPPED WITH TRW STEERING GEARS, MODELS TAS85 AND RCS85, THESE STEERING GEARS CONTAIN POTENTIALLY DEFECTIVE SECTOR SHAFTS WITH AN INCORRECT GEAR TOOTH WHICH MAY INTERFERE WITH THE RACK-PISTON TEETH, RESULTING IN A STICK OR BIND CONDITION.

ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.

ON CERTAIN TRUCKS, A MANUFACTURING ERROR IN THE FUEL-WATER SEPARATOR PREHEATER THERMOSWITCH MAY PREVENT THE FUEL PREHEATER FROM TURNING OFF IF THE IGNITION IS LEFT ON. IF THE IGNITION SWITCH IS LEFT ON WHEN FUEL IS ADDED TO THE FUEL- WATER SEPARATOR AT THE FACTORY OR DURING A FILTER ELEMENT CHANGE, A SMALL FLAME MAY OCCUR INSIDE THE FILTER COVER.

ON CERTAIN TRUCKS EQUIPPED WITH TUFTRAC REAR SUSPENSIONS, THE CENTER CASTING BRACKETS MAY BE OUT OF SPECIFICATION. AN OUT OF SQUARE CASTING MAY HAVE UNACCEPTABLE STRESS IN THE BRACKET WHEN IT IS INSTALLED AND MAY CAUSE IT TO CRACK IN SERVICE.

FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED.

CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

Stop Lamps Intermittent